Searched refs:gcp (Results 1 – 2 of 2) sorted by relevance
| /Zephyr-latest/drivers/usb_c/vbus/ |
| D | usbc_vbus_adc.c | 119 const struct gpio_dt_spec *gcp = &config->power_gpios; in adc_vbus_enable() local
122 if (gcp->port) { in adc_vbus_enable()
123 ret = gpio_pin_set_dt(gcp, enable); in adc_vbus_enable()
138 const struct gpio_dt_spec *gcp = &config->power_gpios; in adc_vbus_init() local
148 if (gcp->port) { in adc_vbus_init()
149 if (!device_is_ready(gcp->port)) { in adc_vbus_init()
150 LOG_ERR("%s: device not ready", gcp->port->name); in adc_vbus_init()
153 ret = gpio_pin_configure_dt(gcp, GPIO_OUTPUT_INACTIVE); in adc_vbus_init()
156 gcp->port->name, gcp->pin, ret); in adc_vbus_init()
|
| /Zephyr-latest/samples/boards/nordic/battery/src/ |
| D | battery.c | 86 const struct gpio_dt_spec *gcp = &cfg->power_gpios; in divider_setup() local
97 if (gcp->port) { in divider_setup()
98 if (!device_is_ready(gcp->port)) { in divider_setup()
99 LOG_ERR("%s: device not ready", gcp->port->name); in divider_setup()
102 rc = gpio_pin_configure_dt(gcp, GPIO_OUTPUT_INACTIVE); in divider_setup()
105 gcp->port->name, gcp->pin, rc); in divider_setup()
161 const struct gpio_dt_spec *gcp = ÷r_config.power_gpios; in battery_measure_enable() local
164 if (gcp->port) { in battery_measure_enable()
165 rc = gpio_pin_set_dt(gcp, enable); in battery_measure_enable()
|
