Searched refs:detect (Results 1 – 25 of 101) sorted by relevance
12345
8 unbound = "detect";
33 unbound = "detect";
11 unbound = "detect";
34 unbound = "detect";
6 Error Detection And Correction is a mechanism used to detect and correct errors
9 * are placed next to each other, the firmware loader will detect the
26 Verify the I2C state register after I2C transfers to detect errors.
26 Note that the PCA95XX cannot reliably detect
29 Note that the PCA_SERIES cannot reliably detect
10 * detect null pointer dereferencing (0x0 - <size>). If the end of the
14 set at 1 V while lower limit is 250 mV. Initially configured to detect
23 bool "Max Peak detect mode"62 acceleration is required to detect activity. It is 3.3 ms per code73 required to detect inactivity. It is 26 ms per code for 3200 Hz ODR
13 cases, the mesh node can't rely on the Configuration Client to detect or determine
10 * Init test: verify the SD host controller can detect card presence, and
29 location counter, and then detect the overflow with an assertion
30 Bluetooth and detect the NRF NUS UUID service.
56 gpio-names = "vbus-detect", "vbus-discharge";
42 because MAX6675 is able to detect if the K-thermocouple is connected or not.
23 # able to detect pthread implementation provided by Zephyr.
35 bool "detect automatically"64 bool "detect APN automatically"
13 client mode it starts BC1.2 detection to detect the attached host
3 The purpose of the test is to detect whether the timer implementation
12 * Init test: verify the SD host controller can detect card presence, and
82 bool "Instance is allowed to set unbound to detect"85 Controls whether the "detect" value of the "unbound"
