Home
last modified time | relevance | path

Searched refs:sda (Results 1 – 25 of 34) sorted by relevance

12

/Zephyr-Core-3.7.0/tests/drivers/i2c/i2c_target_api/boards/
Dxmc47_relax_kit.overlay10 * P3.8, P3.7, P1.9, P3.15 must all be connected (sda related pins)
28 sda-src = "DX0C";
43 sda-src = "DX0A";
/Zephyr-Core-3.7.0/drivers/i2c/
Di2c_esp32.c81 const struct i2c_esp32_pin sda; member
158 gpio_pin_set_dt(&config->sda.gpio, 1); in i2c_esp32_config_pin()
159 ret = gpio_pin_configure_dt(&config->sda.gpio, GPIO_PULL_UP | GPIO_OUTPUT | GPIO_INPUT); in i2c_esp32_config_pin()
160 esp_rom_gpio_matrix_out(config->sda.gpio.pin, config->sda.sig_out, 0, 0); in i2c_esp32_config_pin()
161 esp_rom_gpio_matrix_in(config->sda.gpio.pin, config->sda.sig_in, 0); in i2c_esp32_config_pin()
187 gpio_pin_configure_dt(&config->sda.gpio, GPIO_OUTPUT | GPIO_INPUT); in i2c_master_clear_bus()
193 gpio_pin_set_dt(&config->sda.gpio, 1); in i2c_master_clear_bus()
195 while (!gpio_pin_get_dt(&config->sda.gpio) && (i++ < I2C_CLR_BUS_SCL_NUM)) { in i2c_master_clear_bus()
201 gpio_pin_set_dt(&config->sda.gpio, 0); /* setup for STOP */ in i2c_master_clear_bus()
204 gpio_pin_set_dt(&config->sda.gpio, 1); /* STOP, SDA low -> high while SCL is HIGH */ in i2c_master_clear_bus()
[all …]
Di2c_mcux_lpi2c.c56 struct gpio_dt_spec sda; member
245 gpio_pin_set_dt(&config->sda, state); in mcux_lpi2c_bitbang_set_sda()
252 return gpio_pin_get_dt(&config->sda) == 0 ? 0 : 1; in mcux_lpi2c_bitbang_get_sda()
273 if (!gpio_is_ready_dt(&config->sda)) { in mcux_lpi2c_recover_bus()
286 error = gpio_pin_configure_dt(&config->sda, GPIO_OUTPUT_HIGH); in mcux_lpi2c_recover_bus()
567 #define I2C_MCUX_LPI2C_SDA_INIT(n) .sda = GPIO_DT_SPEC_INST_GET_OR(n, sda_gpios, {0}),
Di2c_ll_stm32.c239 gpio_pin_set_dt(&config->sda, state); in i2c_stm32_bitbang_set_sda()
246 return gpio_pin_get_dt(&config->sda) == 0 ? 0 : 1; in i2c_stm32_bitbang_get_sda()
269 if (!gpio_is_ready_dt(&config->sda)) { in i2c_stm32_recover_bus()
282 error = gpio_pin_configure_dt(&config->sda, GPIO_OUTPUT_HIGH); in i2c_stm32_recover_bus()
600 .sda = GPIO_DT_SPEC_INST_GET_OR(index, sda_gpios, {0}),))\
Di2c_ll_stm32.h40 struct gpio_dt_spec sda; member
Di2c_mchp_xec.c297 gpio_port_value_t sda = 0, scl = 0; in check_lines_high() local
299 if (gpio_port_get_raw(config->sda_gpio.port, &sda)) { in check_lines_high()
306 scl = sda; in check_lines_high()
315 return (sda & BIT(config->sda_gpio.pin)) && (scl & BIT(config->scl_gpio.pin)); in check_lines_high()
Di2c_mcux_lpi2c_rtio.c51 struct gpio_dt_spec sda; member
341 #define I2C_MCUX_LPI2C_SDA_INIT(n) .sda = GPIO_DT_SPEC_INST_GET_OR(n, sda_gpios, {0}),
/Zephyr-Core-3.7.0/dts/arm/infineon/cat3/xmc/
Dxmc4500_F100x1024-pinctrl.dtsi346 pinmux = <XMC4XXX_PINMUX_SET(0, 5, 2)>; /* USIC sda-src = DX0B */
349 pinmux = <XMC4XXX_PINMUX_SET(3, 5, 4)>; /* USIC sda-src = DX0A */
352 pinmux = <XMC4XXX_PINMUX_SET(5, 1, 1)>; /* USIC sda-src = DX0A */
355 pinmux = <XMC4XXX_PINMUX_SET(1, 5, 2)>; /* USIC sda-src = DX0A */
358 pinmux = <XMC4XXX_PINMUX_SET(2, 14, 2)>; /* USIC sda-src = DX0D */
361 pinmux = <XMC4XXX_PINMUX_SET(2, 5, 2)>; /* USIC sda-src = DX0B */
364 pinmux = <XMC4XXX_PINMUX_SET(5, 0, 1)>; /* USIC sda-src = DX0B */
393 pinmux = <XMC4XXX_PINMUX_SET(0, 4, 0)>; /* USIC sda-src = DX0A */
396 pinmux = <XMC4XXX_PINMUX_SET(3, 4, 0)>; /* USIC sda-src = DX0B */
399 pinmux = <XMC4XXX_PINMUX_SET(0, 0, 0)>; /* USIC sda-src = DX0D */
[all …]
Dxmc4700_F144x2048-pinctrl.dtsi598 pinmux = <XMC4XXX_PINMUX_SET(4, 7, 1)>; /* USIC sda-src = DX0C */
601 pinmux = <XMC4XXX_PINMUX_SET(5, 1, 1)>; /* USIC sda-src = DX0A */
604 pinmux = <XMC4XXX_PINMUX_SET(3, 13, 2)>; /* USIC sda-src = DX0D */
607 pinmux = <XMC4XXX_PINMUX_SET(3, 5, 4)>; /* USIC sda-src = DX0A */
610 pinmux = <XMC4XXX_PINMUX_SET(2, 14, 2)>; /* USIC sda-src = DX0D */
613 pinmux = <XMC4XXX_PINMUX_SET(0, 5, 2)>; /* USIC sda-src = DX0B */
616 pinmux = <XMC4XXX_PINMUX_SET(4, 2, 2)>; /* USIC sda-src = DX0C */
619 pinmux = <XMC4XXX_PINMUX_SET(5, 0, 1)>; /* USIC sda-src = DX0B */
622 pinmux = <XMC4XXX_PINMUX_SET(1, 5, 2)>; /* USIC sda-src = DX0A */
625 pinmux = <XMC4XXX_PINMUX_SET(2, 5, 2)>; /* USIC sda-src = DX0B */
[all …]
/Zephyr-Core-3.7.0/boards/microchip/mec15xxevb_assy6853/
Dmec15xxevb_assy6853.dts84 sda-gpios = <MCHP_GPIO_DECODE_003 0>;
93 sda-gpios = <MCHP_GPIO_DECODE_130 0>;
118 sda-gpios = <MCHP_GPIO_DECODE_012 0>;
/Zephyr-Core-3.7.0/tests/drivers/i2c/i2c_api/boards/
Dxmc47_relax_kit.overlay31 sda-src = "DX0D";
/Zephyr-Core-3.7.0/boards/microchip/mec1501modular_assy6885/
Dmec1501modular_assy6885.dts56 sda-gpios = <MCHP_GPIO_DECODE_003 0>;
65 sda-gpios = <MCHP_GPIO_DECODE_130 0>;
/Zephyr-Core-3.7.0/tests/drivers/uart/uart_async_api/boards/
Dxmc47_relax_kit.overlay10 /delete-property/ sda-src;
/Zephyr-Core-3.7.0/boards/m5stack/m5stack_atom_lite/
Dm5stack_atom_lite_procpu.dts69 sda-gpios = <&gpio0 25 GPIO_OPEN_DRAIN>;
79 sda-gpios = <&gpio0 26 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/kincony/kincony_kc868_a32/
Dkincony_kc868_a32_procpu.dts41 sda-gpios = <&gpio0 15 GPIO_OPEN_DRAIN>;
82 sda-gpios = <&gpio0 4 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/samples/subsys/fs/littlefs/
DREADME.rst56 sudo chmod a+rw /dev/sda
57 …_size=512 --prog_size=512 --block_size=512 --cache_size=512 --lookahead_size=8192 --format /dev/sda
58 …512 --prog_size=512 --block_size=512 --cache_size=512 --lookahead_size=8192 /dev/sda ./mnt_littlefs
/Zephyr-Core-3.7.0/boards/silabs/dev_kits/sltb004a/
Dsltb004a.dts160 location-sda = <GECKO_LOCATION(17) GECKO_PORT_C GECKO_PIN(4)>;
166 location-sda = <GECKO_LOCATION(8) GECKO_PORT_B GECKO_PIN(8)>;
/Zephyr-Core-3.7.0/dts/riscv/ite/
Dit81xx2.dtsi365 sda-gpios = <&gpiob 4 0>;
382 sda-gpios = <&gpioc 2 0>;
399 sda-gpios = <&gpiof 7 0>;
415 sda-gpios = <&gpioh 2 0>;
430 sda-gpios = <&gpioe 7 0>;
445 sda-gpios = <&gpioa 5 0>;
/Zephyr-Core-3.7.0/boards/m5stack/m5stack_core2/
Dm5stack_core2_procpu.dts107 sda-gpios = <&gpio0 21 GPIO_OPEN_DRAIN>;
195 sda-gpios = <&gpio1 0 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/nxp/twr_ke18f/
Dtwr_ke18f.dts246 sda-gpios = <&gpioa 2 GPIO_ACTIVE_HIGH>;
260 sda-gpios = <&gpiod 8 GPIO_ACTIVE_HIGH>;
/Zephyr-Core-3.7.0/boards/espressif/esp32_devkitc_wroom/
Desp32_devkitc_wroom_procpu.dts85 sda-gpios = <&gpio0 21 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/espressif/esp32_devkitc_wrover/
Desp32_devkitc_wrover_procpu.dts85 sda-gpios = <&gpio0 21 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/lilygo/ttgo_lora32/
Dttgo_lora32_esp32_procpu.dts62 sda-gpios = <&gpio0 21 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/vcc-gnd/yd_esp32/
Dyd_esp32_procpu.dts81 sda-gpios = <&gpio0 21 GPIO_OPEN_DRAIN>;
/Zephyr-Core-3.7.0/boards/olimex/olimex_esp32_evb/
Dolimex_esp32_evb_procpu.dts78 sda-gpios = <&gpio0 16 GPIO_OPEN_DRAIN>;

12