Searched refs:pull_down (Results 1 – 9 of 9) sorted by relevance
| /Zephyr-Core-3.7.0/soc/nuvoton/numicro/common/ |
| D | pinctrl_soc.h | 20 uint32_t pull_down : 1; member
34 .pull_down = DT_PROP(node_id, bias_pull_down), \
|
| /Zephyr-Core-3.7.0/soc/quicklogic/eos_s3/ |
| D | pinctrl_soc.h | 22 uint32_t pull_down: 1; member
37 .pull_down = DT_PROP(node_id, bias_pull_down), \
|
| /Zephyr-Core-3.7.0/soc/renesas/rzt2m/ |
| D | pinctrl_soc.h | 23 uint32_t pull_down: 1; member
41 .pull_down = DT_PROP(node_id, bias_pull_down), \
|
| /Zephyr-Core-3.7.0/drivers/gpio/ |
| D | gpio_cy8c95xx.c | 29 uint8_t pull_down; member
81 rc = i2c_reg_write_byte_dt(&cfg->i2c, CY8C95XX_REG_PULL_DOWN, pins->pull_down); in write_pin_state()
107 WRITE_BIT(pins->pull_down, pin, (flags & GPIO_PULL_DOWN) != 0U); in cy8c95xx_config()
252 .pull_down = 0x00, in cy8c95xx_init()
|
| D | gpio_sx1509b.c | 44 uint16_t pull_down; /* 0x08 */ member
257 pin_buf.pins.pull_down = sys_cpu_to_be16(pins->pull_down); in write_pin_state()
324 pins->pull_down |= BIT(pin); in sx1509b_config()
326 pins->pull_down &= ~BIT(pin); in sx1509b_config()
356 pins->input_disable, pins->pull_up, pins->pull_down, in sx1509b_config()
|
| /Zephyr-Core-3.7.0/drivers/pinctrl/ |
| D | pinctrl_eos_s3.c | 106 } else if (pin->pull_up | pin->pull_down) { in pinctrl_eos_s3_configure_pin()
108 WRITE_BIT(reg_value, PAD_PULL_DOWN_BIT, pin->pull_down); in pinctrl_eos_s3_configure_pin()
|
| D | pinctrl_numicro.c | 69 } else if (pin->pull_down != 0) { in gpio_configure()
|
| /Zephyr-Core-3.7.0/samples/shields/npm6001_ek/src/ |
| D | main.c | 302 static int high_drive, pull_down, cmos; in cmd_gpio_configure() local
310 {"pull-down", no_argument, &pull_down, 1}, in cmd_gpio_configure()
316 pull_down = 0; in cmd_gpio_configure()
345 if (pull_down == 1) { in cmd_gpio_configure()
|
| /Zephyr-Core-3.7.0/drivers/pinctrl/renesas/rz/ |
| D | pinctrl_rzt2m.c | 43 pin->drive_strength, (pin->pull_up == 1 ? 1U : (pin->pull_down == 1 ? 2U : 0)), in pinctrl_configure_pin()
|
