Searched refs:ev_enable_addr (Results 1 – 2 of 2) sorted by relevance
| /Zephyr-Core-3.7.0/drivers/serial/ |
| D | uart_litex.c | 28 uint32_t ev_enable_addr; member
99 uint8_t enable = litex_read8(config->ev_enable_addr); in uart_litex_irq_tx_enable()
101 litex_write8(enable | UART_EV_TX, config->ev_enable_addr); in uart_litex_irq_tx_enable()
122 uint8_t enable = litex_read8(config->ev_enable_addr); in uart_litex_irq_tx_disable()
124 litex_write8(enable & ~(UART_EV_TX), config->ev_enable_addr); in uart_litex_irq_tx_disable()
136 uint8_t enable = litex_read8(config->ev_enable_addr); in uart_litex_irq_rx_enable()
138 litex_write8(enable | UART_EV_RX, config->ev_enable_addr); in uart_litex_irq_rx_enable()
150 uint8_t enable = litex_read8(config->ev_enable_addr); in uart_litex_irq_rx_disable()
152 litex_write8(enable & ~(UART_EV_RX), config->ev_enable_addr); in uart_litex_irq_rx_disable()
363 .ev_enable_addr = DT_INST_REG_ADDR_BY_NAME(n, ev_enable), \
|
| /Zephyr-Core-3.7.0/drivers/gpio/ |
| D | gpio_litex.c | 42 uint32_t ev_enable_addr; member
201 litex_read(gpio_config->ev_enable_addr, gpio_config->reg_size); in gpio_litex_irq_handler()
230 uint8_t ev_enabled = litex_read(gpio_config->ev_enable_addr, in gpio_litex_pin_interrupt_configure()
237 litex_write(gpio_config->ev_enable_addr, gpio_config->reg_size, in gpio_litex_pin_interrupt_configure()
261 uint8_t ev_enabled = litex_read(gpio_config->ev_enable_addr, in gpio_litex_pin_interrupt_configure()
263 litex_write(gpio_config->ev_enable_addr, gpio_config->reg_size, in gpio_litex_pin_interrupt_configure()
326 .ev_enable_addr = DT_INST_REG_ADDR_BY_NAME(n, irq_en), \
|
