Searched refs:port_num (Results 1 – 12 of 12) sorted by relevance
| /Zephyr-Core-3.6.0/drivers/gpio/ |
| D | gpio_lpc11u6x.c | 94 uint8_t port_num; member
111 uint8_t port_num = config->port_num; in gpio_lpc11u6x_pin_configure() local
124 if (port_num == 0 && (pin == 4 || pin == 5) && in gpio_lpc11u6x_pin_configure()
134 if (port_num == 0 && (pin == 0 || (pin >= 10 && pin <= 15))) { in gpio_lpc11u6x_pin_configure()
158 if (port_num == 2 && pin > 1) { in gpio_lpc11u6x_pin_configure()
168 gpio_regs->set[port_num] |= BIT(pin); in gpio_lpc11u6x_pin_configure()
172 gpio_regs->clr[port_num] |= BIT(pin); in gpio_lpc11u6x_pin_configure()
181 WRITE_BIT(gpio_regs->dir[port_num], pin, flags & GPIO_OUTPUT); in gpio_lpc11u6x_pin_configure()
193 *value = gpio_regs->pin[config->port_num]; in gpio_lpc11u6x_port_get_raw()
205 uint8_t port_num = config->port_num; in gpio_lpc11u6x_port_set_masked_raw() local
[all …]
|
| D | gpio_cy8c95xx.c | 45 uint8_t port_num; member
60 rc = i2c_reg_write_byte_dt(&cfg->i2c, CY8C95XX_REG_OUTPUT_DATA0 + cfg->port_num, in write_pin_state()
66 rc = i2c_reg_write_byte_dt(&cfg->i2c, CY8C95XX_REG_PORT_SELECT, cfg->port_num); in write_pin_state()
152 rc = i2c_reg_read_byte_dt(&cfg->i2c, CY8C95XX_REG_INPUT_DATA0 + cfg->port_num, &pin_data); in port_get()
179 int rc = i2c_reg_write_byte_dt(&cfg->i2c, CY8C95XX_REG_OUTPUT_DATA0 + cfg->port_num, out); in port_write()
282 .port_num = DT_INST_REG_ADDR(idx), \
|
| D | gpio_mchp_xec.c | 21 ((__IO uint32_t *)(GPIO_PARIN_BASE + (config->port_num << 2)))
24 ((__IO uint32_t *)(GPIO_PAROUT_BASE + (config->port_num << 2)))
47 uint32_t port_num; member
71 if ((valid_ctrl_masks[config->port_num] & BIT(pin)) == 0U) { in gpio_xec_configure()
173 if ((valid_ctrl_masks[config->port_num] & BIT(pin)) == 0U) { in gpio_xec_pin_interrupt_configure()
353 .port_num = MCHP_GPIO_000_036,
399 .port_num = MCHP_GPIO_040_076,
445 .port_num = MCHP_GPIO_100_136,
491 .port_num = MCHP_GPIO_140_176,
537 .port_num = MCHP_GPIO_200_236,
[all …]
|
| D | gpio_mchp_xec_v2.c | 45 uint8_t port_num; member
131 if (!(valid_ctrl_masks[config->port_num] & BIT(pin))) { in gpio_xec_configure()
263 if ((valid_ctrl_masks[config->port_num] & BIT(pin)) == 0U) { in gpio_xec_pin_interrupt_configure()
391 uint32_t valid_msk = valid_ctrl_masks[config->port_num]; in gpio_xec_get_direction()
427 uint32_t valid_msk = valid_ctrl_masks[config->port_num]; in gpio_xec_get_config()
533 .port_num = DT_INST_PROP(n, port_id), \
|
| D | gpio_cc32xx.c | 53 uint8_t port_num; member
87 MAP_PinTypeGPIO(pinTable[gpio_config->port_num * 8 + pin], in gpio_cc32xx_config()
271 .port_num = n \
|
| D | gpio_davinci.c | 61 uint32_t port_num; member
187 .port_num = n, \
|
| D | gpio_nrfx.c | 28 uint8_t port_num; member
65 nrfx_gpiote_pin_t abs_pin = NRF_GPIO_PIN_MAP(cfg->port_num, pin); in gpio_nrfx_pin_configure()
256 uint32_t abs_pin = NRF_GPIO_PIN_MAP(cfg->port_num, pin); in gpio_nrfx_pin_interrupt_configure()
461 .port_num = DT_INST_PROP(id, port), \
|
| D | gpio_ifx_cat1.c | 200 uint32_t port_num = CYHAL_GET_PORT((uint32_t) callback_arg); in gpio_event_callback() local
202 const struct device *dev = port_dev_obj[port_num]; in gpio_event_callback()
|
| /Zephyr-Core-3.6.0/drivers/pinctrl/ |
| D | pinctrl_ifx_cat1.c | 99 uint32_t port_num = CAT1_PINMUX_GET_PORT_NUM(pins[i].pinmux); in pinctrl_configure_pins() local
103 Cy_GPIO_Pin_FastInit(gpio_ports[port_num], pin_num, drv_mode, 1, hsiom); in pinctrl_configure_pins()
108 Cy_GPIO_Write(gpio_ports[port_num], pin_num, 1); in pinctrl_configure_pins()
111 Cy_GPIO_Write(gpio_ports[port_num], pin_num, 0); in pinctrl_configure_pins()
|
| /Zephyr-Core-3.6.0/drivers/serial/ |
| D | uart_ite_it8xxx2.c | 192 .port = DT_INST_PROP(inst, port_num), \
|
| /Zephyr-Core-3.6.0/drivers/i2c/ |
| D | i2c_ite_it8xxx2.c | 1298 .port = DT_INST_PROP(inst, port_num), \
|
| D | i2c_ite_enhance.c | 1475 .port = DT_INST_PROP(inst, port_num), \
|
