Searched refs:npcx_miwu_interrupt_configure (Results 1 – 9 of 9) sorted by relevance
| /Zephyr-Core-3.5.0/soc/arm/nuvoton_npcx/common/ |
| D | soc_miwu.h | 190 int npcx_miwu_interrupt_configure(const struct npcx_wui *wui,
|
| /Zephyr-Core-3.5.0/drivers/watchdog/ |
| D | wdt_npcx.c | 163 npcx_miwu_interrupt_configure(&config->t0out, in wdt_config_t0out_interrupt()
|
| /Zephyr-Core-3.5.0/drivers/gpio/ |
| D | gpio_npcx.c | 341 ret = npcx_miwu_interrupt_configure(&config->wui_maps[pin], in gpio_npcx_pin_interrupt_configure()
|
| /Zephyr-Core-3.5.0/drivers/interrupt_controller/ |
| D | intc_miwu.c | 194 int npcx_miwu_interrupt_configure(const struct npcx_wui *wui, in npcx_miwu_interrupt_configure() function
|
| /Zephyr-Core-3.5.0/drivers/input/ |
| D | input_npcx_kbd.c | 407 npcx_miwu_interrupt_configure(wui, NPCX_MIWU_MODE_EDGE, NPCX_MIWU_TRIG_BOTH); in input_npcx_kbd_init_ksi_wui_callback()
|
| /Zephyr-Core-3.5.0/drivers/serial/ |
| D | uart_npcx.c | 528 npcx_miwu_interrupt_configure(&config->uart_rx_wui, NPCX_MIWU_MODE_EDGE, in uart_npcx_init()
|
| /Zephyr-Core-3.5.0/subsys/mgmt/ec_host_cmd/backends/ |
| D | ec_host_cmd_backend_shi_npcx.c | 845 npcx_miwu_interrupt_configure(&config->shi_cs_wui, NPCX_MIWU_MODE_EDGE, NPCX_MIWU_TRIG_LOW); in shi_npcx_init_registers()
|
| /Zephyr-Core-3.5.0/drivers/espi/ |
| D | host_subs_npcx.c | 1176 npcx_miwu_interrupt_configure(&host_sub_cfg.host_acc_wui, in npcx_host_init_subs_core_domain()
|
| D | espi_npcx.c | 206 npcx_miwu_interrupt_configure(wui, NPCX_MIWU_MODE_EDGE, in espi_init_wui_callback()
|
