Searched refs:int_pin (Results 1 – 15 of 15) sorted by relevance
| /Zephyr-Core-3.4.0/drivers/sensor/mpu9250/ |
| D | mpu9250_trigger.c | 31 ret = gpio_pin_interrupt_configure_dt(&cfg->int_pin, GPIO_INT_DISABLE); in mpu9250_trigger_set()
44 ret = gpio_pin_interrupt_configure_dt(&cfg->int_pin, in mpu9250_trigger_set()
64 ret = gpio_pin_interrupt_configure_dt(&cfg->int_pin, GPIO_INT_DISABLE); in mpu9250_gpio_callback()
88 ret = gpio_pin_interrupt_configure_dt(&cfg->int_pin, in mpu9250_thread_cb()
123 if (!device_is_ready(cfg->int_pin.port)) { in mpu9250_init_interrupt()
130 ret = gpio_pin_configure_dt(&cfg->int_pin, GPIO_INPUT); in mpu9250_init_interrupt()
138 BIT(cfg->int_pin.pin)); in mpu9250_init_interrupt()
140 ret = gpio_add_callback(cfg->int_pin.port, &drv_data->gpio_cb); in mpu9250_init_interrupt()
170 ret = gpio_pin_interrupt_configure_dt(&cfg->int_pin, in mpu9250_init_interrupt()
|
| D | mpu9250.h | 66 const struct gpio_dt_spec int_pin; member
|
| D | mpu9250.c | 358 (.int_pin = GPIO_DT_SPEC_INST_GET(inst, irq_gpios))) \
|
| /Zephyr-Core-3.4.0/drivers/sensor/lsm6dso/ |
| D | lsm6dso_trigger.c | 40 if (cfg->int_pin == 1) in lsm6dso_enable_t_int()
66 if (cfg->int_pin == 1) { in lsm6dso_enable_xl_int()
102 if (cfg->int_pin == 1) { in lsm6dso_enable_g_int()
|
| D | lsm6dso.h | 64 uint8_t int_pin; member
|
| D | lsm6dso.c | 901 .int_pin = DT_INST_PROP(inst, int_pin)
|
| /Zephyr-Core-3.4.0/drivers/sensor/ism330dhcx/ |
| D | ism330dhcx_trigger.c | 40 if (cfg->int_pin == 1) in ism330dhcx_enable_t_int()
67 if (cfg->int_pin == 1) { in ism330dhcx_enable_xl_int()
103 if (cfg->int_pin == 1) { in ism330dhcx_enable_g_int()
|
| D | ism330dhcx.h | 44 uint8_t int_pin; member
|
| D | ism330dhcx.c | 784 .int_pin = DT_INST_PROP_OR(inst, int_pin, 0),)) \
|
| /Zephyr-Core-3.4.0/drivers/sensor/iis2iclx/ |
| D | iis2iclx.h | 53 uint8_t int_pin; member
|
| D | iis2iclx_trigger.c | 39 if (cfg->int_pin == 1) in iis2iclx_enable_t_int()
65 if (cfg->int_pin == 1) { in iis2iclx_enable_xl_int()
|
| D | iis2iclx.c | 649 .int_pin = DT_INST_PROP(inst, int_pin)
|
| /Zephyr-Core-3.4.0/drivers/sensor/lis2dw12/ |
| D | lis2dw12.h | 87 uint8_t int_pin; member
|
| D | lis2dw12_trigger.c | 34 if (cfg->int_pin == 1) { in lis2dw12_enable_int()
448 LOG_INF("%s: int-pin is on INT%d", dev->name, cfg->int_pin); in lis2dw12_init_interrupt()
|
| D | lis2dw12.c | 527 .int_pin = DT_INST_PROP(inst, int_pin),
|
