Searched full:versa (Results 1 – 25 of 37) sorted by relevance
12
| /Zephyr-latest/dts/bindings/power/ |
| D | nxp,s32k3-pmc.yaml | 27 regulator mode and vice versa, depending on the V15 voltage status.
|
| /Zephyr-latest/doc/project/ |
| D | issues.rst | 8 relevant GitHub issues and vice versa.
|
| /Zephyr-latest/subsys/bluetooth/mesh/ |
| D | brg_cfg.h | 23 * 2 - bridge messages with src as addr1 and dst as addr2 and vice-versa
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | ti,ina226.yaml | 62 Higher resolution means lower range of current measurement, vice versa.
|
| /Zephyr-latest/drivers/display/ |
| D | display_st7796s.c | 113 * Blue in D[0:4] and vice versa for BGR565. in st7796s_get_pixelfmt()
120 * and vice versa. in st7796s_get_pixelfmt()
140 * Report pixel format as RGB if MADCTL setting is BGR and vice versa in st7796s_get_pixelfmt()
|
| D | display_st7735r.c | 261 * is BGR. And also vice versa. in st7735r_get_capabilities()
|
| /Zephyr-latest/doc/connectivity/networking/ |
| D | qemu_user_setup.rst | 71 8080 of guest, and vice versa.
|
| /Zephyr-latest/soc/native/inf_clock/ |
| D | soc.c | 23 * HW models run or vice versa
|
| /Zephyr-latest/tests/drivers/gpio/gpio_api_1pin/src/ |
| D | test_pin.c | 58 * inactive and vice versa.
100 * to inactive and vice versa.
|
| D | test_port.c | 109 * inactive and vice versa.
|
| /Zephyr-latest/include/zephyr/llext/ |
| D | symbol.h | 24 * symbols from the base image to extensions and vice versa, so that proper
|
| /Zephyr-latest/drivers/sensor/microchip/tcn75a/ |
| D | tcn75a_trigger.c | 124 * it falls below T_HYST (or vice versa for falling below T_HYST). in tcn75a_handle_int()
|
| /Zephyr-latest/drivers/interrupt_controller/ |
| D | intc_xmc4xxx.c | 24 /* unset on a negative edge (or vice-versa depending on the configuration). The value of */
|
| /Zephyr-latest/include/zephyr/usb/class/ |
| D | usbd_hid.h | 152 * Boot Protocol(0) to Report Protocol(1) or vice versa.
|
| /Zephyr-latest/drivers/fuel_gauge/max17048/ |
| D | max17048.c | 239 * charging (and vice versa) especially if your device consumes little power in max17048_get_prop()
|
| /Zephyr-latest/subsys/net/lib/sockets/ |
| D | Kconfig | 24 socket creation over the native one, or vice versa.
|
| /Zephyr-latest/subsys/bluetooth/audio/ |
| D | gmap_server.c | 282 "BT_GMAP_BGR_FEAT_MULTIPLEX is supported, and vice versa"); in valid_gmap_features()
|
| /Zephyr-latest/doc/connectivity/bluetooth/ |
| D | bluetooth-le-host.rst | 20 host, and vice-versa.
|
| /Zephyr-latest/drivers/counter/ |
| D | counter_smartbond_timer.c | 83 * a timer block will automatically be switched from DIVN to LP and vice versa.
|
| /Zephyr-latest/drivers/can/ |
| D | can_nxp_s32_canxl.c | 24 * vice versa.
37 * versa.
|
| D | can_mcux_flexcan.c | 51 * vice versa.
58 * versa.
|
| /Zephyr-latest/drivers/dma/ |
| D | dma_nxp_edma.h | 155 * data, the other will consume and vice-versa.
|
| /Zephyr-latest/doc/kernel/services/threads/ |
| D | index.rst | 251 a cooperative thread, and vice versa, by changing its priority.
|
| /Zephyr-latest/include/zephyr/drivers/ |
| D | i2s.h | 200 * is being populated while the other is being played (DMAed) and vice versa.
|
| /Zephyr-latest/kernel/ |
| D | Kconfig | 957 and vice versa. This might not be acceptable in all scenarios,
|
12
