Searched full:tells (Results 1 – 25 of 125) sorted by relevance
12345
21 This tells the driver to configure the UART port at boot, depending on29 This tells the driver to configure the UART port at boot, depending on37 This tells the driver to configure the UART port at boot, depending on
21 This tells the driver to configure the UART port at boot, depending on44 This tells the driver to configure the UART port at boot, depending on
33 The TX time tells how long it took for network packet from its creation to34 when it was sent to the network. The RX time tells the time from its creation67 sent. The value **63** tells also the same information, but is calculated80 * The last value tells how long it took from there to the application. Here83 sent. The value **42** tells also the same information, but is calculated
28 This tells how many net_pkt to allocate for capturing38 This tells how many net_buf to allocate for capturing
16 Tells what Qemu network model to use. This value is given as
18 Tells what Qemu network model to use. This value is given as
20 Tells what Qemu network model to use. This value is given as
35 ":kconfig:option:`CONFIG_NET_CONFIG_INIT_TIMEOUT`", "This tells how long to wait for50 this option tells that the network application needs IPv6 router to exists
12 * A magic that tells ROM to jump to imr_restore_vector instead of normal boot
16 * A magic that tells ROM to jump to imr_restore_vector instead of normal boot
13 device that tells the system that the device is capable of
34 * description and tells the linker that this section is located in41 * description and tells the linker that this a read-only section
80 * description and tells the linker that this section is located in102 * description and tells the linker that this a read-only section
21 Tells how many IPIP tunnels are supported.
49 * This tells the coredump subsys to finalize the coredump
22 This tells how many network interfaces there will be in the system99 will timeout. RFC 2460 chapter 4.5 tells to wait for 60 seconds but
36 sent to server. This number tells how many syslog messages can be
57 This tells what is the expected sending time of the network
137 The -o option tells minicom not to send the modem initialization197 The -o option tells minicom not to send the modem initialization
129 The -o option tells minicom not to send the modem initialization190 The -o option tells minicom not to send the modem initialization
26 * Tells the Remote Provisioning Server not to put restrictions on the max123 * Tells the Remote Provisioning Server to start scanning for unprovisioned
163 this simulation; the ``-D`` option tells the Phy how many devices will be run164 in this simulation; the ``-d`` option tells each device which is its device
46 This tells the driver to which SoC UART to direct the UART traffic
49 Tells whether LLDPDU packet will have marker at the end of the packet.
