Searched full:resistors (Results 1 – 25 of 42) sorted by relevance
12
13 pin-v1-voltage-divider-resistors = <500 1000>;14 pin-v2-voltage-divider-resistors = <110000 100000>;15 pin-v3-voltage-divider-resistors = <7000 1000>;16 pin-v4-voltage-divider-resistors = <500 1000>;27 pin-v1-voltage-divider-resistors = <0 1>;28 pin-v2-voltage-divider-resistors = <0 1>;29 pin-v3-voltage-divider-resistors = <0 1>;30 pin-v4-voltage-divider-resistors = <0 1>;39 pin-v1-voltage-divider-resistors = <0 1>;40 pin-v2-voltage-divider-resistors = <0 1>;[all …]
68 pin-v1-voltage-divider-resistors:72 pin-v2-voltage-divider-resistors:80 pin-v3-voltage-divider-resistors:84 pin-v4-voltage-divider-resistors:
85 shunt-resistors:
20 resistors. It also provides a way to sense and report what resistors are
11 * level shifter (preferred) or pull-up resistors are needed.13 * resistors.
15 * are connected to pull-up resistors also.
9 * Note: this sample requires the board to be modified! Populate resistors
29 using you might need to connect two 10K ohm resistors to SDL and SDA (I2C).
28 On some boards you will need to use 2 pull-up resistors (10k Ohm) between the
68 high using pullup/pulldown resistors.
26 resistors.
25 resistors.
24 resistors.
31 resistors.
14 and CC2 need to be disconnected from their pull-down resistors and be connected to PB6 and18 The pull-downs are disconnected by removing the zero-Ohm resistors on SB8 and SB9 next to88 | SB8/SB9 | Closed | Connect USB-CCx to pull-down resistors |
22 * (Resistors J8 and J9, should be populated by default)
53 /* requires resoldering of resistors on the board */
38 by external resistors to avoid floating pins. When triggering a wake up, one
38 Shield configuration could be modified by moving resistors or changing jumper as
36 resistors.
24 /** Performs on/off control of the pull resistors */
23 /** Performs on/off control of the pull resistors */
42 Shield configuration could be modified by moving resistors as
720 shunt-resistors = <1000 1000 1000>;810 pin-v1-voltage-divider-resistors = <100 10>;811 pin-v2-voltage-divider-resistors = <100 10>;812 pin-v3-voltage-divider-resistors = <100 100>;813 pin-v4-voltage-divider-resistors = <0 1>;
76 /* Two zero ohm resistors (R256 and R270) isolate sensor
