Searched full:rate (Results 1 – 8 of 8) sorted by relevance
| /mcuboot-latest/sim/simflash/src/ |
| D | lib.rs | 59 fn add_bad_region(&mut self, offset: usize, len: usize, rate: f32) -> Result<()>; in add_bad_region()
183 for &(off, len, rate) in &self.bad_region { in write()
187 if samp < rate { in write()
231 /// given by `rate`.
232 fn add_bad_region(&mut self, offset: usize, len: usize, rate: f32) -> Result<()> { in add_bad_region()
233 if !(0.0..=1.0).contains(&rate) { in add_bad_region()
234 bail!(ebounds("Invalid rate")); in add_bad_region()
238 self.bad_region.push((offset, len, rate)); in add_bad_region()
|
| /mcuboot-latest/boot/cypress/libs/retarget_io_pdl/ |
| D | cy_retarget_io_pdl.h | 43 /** UART baud rate */
|
| /mcuboot-latest/boot/cypress/platforms/retarget_io_pdl/ |
| D | cy_retarget_io_pdl.h | 43 /** UART baud rate */
|
| /mcuboot-latest/boot/boot_serial/ |
| D | syscfg.yml | 72 The toggle rate, in Hz, of the serial boot loader report pin.
|
| /mcuboot-latest/boot/espressif/ |
| D | CMakeLists.txt | 171 # Serial baud rate parameter for esptool.py flash use, for more information, check `esptool.py -h`
|
| /mcuboot-latest/ext/mbedtls-asn1/include/mbedtls/ |
| D | bignum.h | 980 …MBEDTLS_MPI_GEN_PRIME_FLAG_LOW_ERR = 0x0002, /**< lower error rate from 2<sup>-80</sup> to 2<sup>-…
|
| /mcuboot-latest/sim/src/ |
| D | image.rs | 1378 rate: f32) { in mark_bad_status_with_rate()
1393 let _ = dev.add_bad_region(status_off, self.status_sz(align), rate); in mark_bad_status_with_rate()
|
| /mcuboot-latest/docs/ |
| D | readme-espressif.md | 135 You may adjust the port `<PORT>` (like `/dev/ttyUSB0`) and baud rate `<BAUD>` (like `2000000`)
|
