Searched full:power (Results 1 – 16 of 16) sorted by relevance
14 * resistant to asynchronous power failures or it can use hardware20 * their value cannot decrease due to any kind of power failure.
22 UART console receive buffer size; must be power of 2.
44 # Power management
244 /* Set worst case memory wait states (! ultra low power, 150 MHz), will update at the end */ in init_cycfg_system()250 #warning Power system will not be configured. Update power personality to v1.20 or later. in init_cycfg_system()
61 /* Enable and disable cc310 to reduce power consumption */
109 * This function is NOT power failsafe since the image is decrypted in the RAM201 * in place. this operation is not power failsafe.
124 * There is no power-safe way to erase flash partially in psoc6_smif_erase()
102 // Verify that the alignment is a positive power of two. in new()198 // Verify the alignment (which must be a power of two). in write()
105 and will be a small power of two. By default, the Zephyr build system will
283 * Glitch detection can be falsely triggered by EMI interference (high RF TX power, etc) in main()
18 "control" means (i) the power, direct or indirect, to cause the
69 # CONFIG_TEXT_SECTION_OFFSET. This value needs to be a power of two
112 .long lpcomp_interrupt_IRQHandler /* Low Power Comparator Interrupt */542 def_irq_handler lpcomp_interrupt_IRQHandler /* Low Power Comparator Interrupt */
485 No hardening in SW against hardware level fault injection: power or
3155 * a power of two should be preferred.
3441 * a power of two should be preferred.
