Searched full:opposite (Results 1 – 25 of 47) sorted by relevance
12
| /Zephyr-latest/dts/bindings/gpio/ |
| D | arduino-header-r3.yaml | 9 opposite edges of the board.
16 * An 8-pin header (opposite Analog Input). This has digital input
18 * A 10-pin header (opposite Power Supply). This has six additional
|
| D | panasonic,reduced-arduino-header.yaml | 39 3. 8-pin header (opposite Analog Input). Digital input signals, like on
43 4. 10-pin header (opposite Power Supply). Digital input signals, like on
|
| D | adafruit-feather-header.yaml | 8 opposite edges of the board.
|
| D | seeed-xiao-header.yaml | 9 The Seeeeduino Xiao layout provides two headers, along opposite
|
| D | sparkfun-pro-micro-header.yaml | 7 The Sparkfun Pro Micro layout provides two headers, along opposite
|
| D | arduino-nano-header-r3.yaml | 7 The Arduino Nano layout provides two headers on opposite edges of the board.
|
| D | mikro-bus.yaml | 7 The Mikro BUS layout provides two headers, aligned on the opposite
|
| /Zephyr-latest/drivers/flash/ |
| D | Kconfig.simulator | 32 to the opposite.
47 opposite.
50 but only change from erase-value to opposite will be registered.
|
| D | Kconfig | 27 to the opposite.
65 can change storage bits, by write, from any value to opposite
|
| /Zephyr-latest/include/zephyr/drivers/flash/ |
| D | stm32_flash_api_extensions.h | 18 * is used to do the opposite. If both masks are 0, then protection will
|
| /Zephyr-latest/include/zephyr/dt-bindings/gpio/ |
| D | gpio.h | 61 * mode opposite to 'Open Drain'. It behaves like a switch that is either
|
| /Zephyr-latest/samples/drivers/misc/grove_display/src/ |
| D | main.c | 75 * Second half is opposite (i.e. goes darker). in main()
|
| /Zephyr-latest/boards/sipeed/longan_nano/doc/ |
| D | index.rst | 79 USART0 is on the opposite end of the USB.
|
| /Zephyr-latest/soc/native/inf_clock/ |
| D | soc.c | 45 * and waits until somebody else changes it to the opposite
|
| /Zephyr-latest/subsys/mgmt/mcumgr/grp/img_mgmt/src/ |
| D | img_mgmt_state.c | 151 /* All cases except BOOT_SWAP_TYPE_NONE return opposite slot */ in img_mgmt_get_next_boot_slot()
164 * to the application in the opposite to active slot. in img_mgmt_get_next_boot_slot()
499 /* _a is active slot, _o is opposite slot */ in img_mgmt_state_read()
633 /* Normal boot means confirmed boot to either active slot or the opposite slot. */ in img_mgmt_set_next_boot_slot()
|
| /Zephyr-latest/drivers/usb/udc/ |
| D | udc_skeleton.c | 146 * Opposite function to udc_skeleton_ep_enable(). udc_ep_disable_internal()
169 * Opposite to halt endpoint. If there are requests in the endpoint queue,
|
| /Zephyr-latest/doc/services/ipc/ipc_service/backends/ |
| D | ipc_service_icmsg.rst | 103 The other pair is symmetric and transfers messages in the opposite direction.
|
| /Zephyr-latest/arch/sparc/core/ |
| D | fatal.c | 71 * appear. RESTORE does the opposite.
|
| /Zephyr-latest/scripts/native_simulator/common/src/ |
| D | nce.c | 128 * and waits until somebody else changes it to the opposite
|
| /Zephyr-latest/drivers/gpio/ |
| D | gpio_sam.c | 105 * A pull cannot be enabled if the opposite pull is enabled. in gpio_sam_port_configure()
|
| /Zephyr-latest/tests/kernel/sched/deadline/src/ |
| D | main.c | 75 * deadlines end up in the opposite order due to the in ZTEST()
|
| /Zephyr-latest/tests/kernel/sched/preempt/src/ |
| D | main.c | 219 * policy OR the opposite ("run newly woken in validate_wakeup()
|
| /Zephyr-latest/drivers/rtc/ |
| D | rtc_ll_stm32.c | 577 * the opposite of Zephyr RTC Alarm mask which is set for active fields. in rtc_stm32_init_ll_alrm_struct()
651 * the opposite of Zephyr RTC Alarm mask which is set for active fields. in rtc_stm32_get_ll_alrm_mask()
972 * on clock period (not frequency) but with an opposite sign in rtc_stm32_set_calibration()
|
| /Zephyr-latest/include/zephyr/arch/nios2/ |
| D | nios2.h | 196 * opposite should be used for register writes when starting
|
| /Zephyr-latest/include/zephyr/sys/ |
| D | bitarray.h | 300 * it is set to opposite state. The check and set is performed as a single
|
12
