Searched full:numbering (Results 1 – 25 of 29) sorted by relevance
12
32 * @param irq The IRQ number in the Zephyr irq.h numbering system45 * @param The IRQ number in the Zephyr <irq.h> numbering system63 * to get, in the Zephyr <irq.h> numbering system72 * by channel in the event unit IRQ numbering assignment, in rv32m1_intmux_channel()89 * <irq.h> numbering system
11 This driver is very similar to ADS7843, but differs on channel numbering.
35 # The numbering of the format types should be consistent across
8 "shields" but use a different orientation and pin numbering scheme.
15 non-monotonically decreasing numbering.
94 General information on module pin numbering97 The numbering of the pins on the module and EVK do not follow the GPIO98 numbering on the nRF52832 SoC. Please see the `ANNA-B1 Data Sheet`_ for99 information on how to map ANNA-B1 pins to the pin numbering on the
101 General information on module pin numbering104 The numbering of the pins on the module and EVK do not follow the GPIO105 numbering on the nRF52832 SoC. Please see the `NINA-B1 Data Sheet`_ for106 information on how to map NINA-B1 pins to the pin numbering on the
96 General information on module pin numbering99 The numbering of the pins on the module and EVK do not follow the GPIO100 numbering on the nRF52833 SoC. Please see the `NINA-B40 Data Sheet`_ for101 information on how to map NINA-B40 pins to the pin numbering on the
32 to IEEE 802.15.4-2020 section, table and figure numbering - unless otherwise
24 * immediately after the Xtensa interrupt space in the numbering
176 "Interfaces numbering failed"); in check_endpoint_allocation()
202 /* Adding 1 since line numbering on the display starts with 1 */ in ls0xx_write()
13 * numbering. These macros do not require the user to do octal arithmetic
109 /* For EV_ProtV, the numbering/semantics of the parameter are consistent across
232 /* Indexed from 1 to match JESD216 data word numbering */
534 * the peripheral number by SoC numbering. We therefore cannot use
287 multilevel interrupt numbering.
57 * This numbering only affects the ECIA BLOCK_EN_SET, BLOCK_EN_CLR, and1118 /* GIRQ numbering */
684 * numbering requirements from Universal Serial Bus Specification Revision 2.0686 * actual USB stack endpoint fixup (so the fixup does not break the numbering).
180 zero-based numbering. When using with Zephyr host this option can be
143 * about peculiarities of channel pages and channel numbering:167 * bit numbering.
485 * efficiently in kernel context. Note that while the numbering of
126 * The numbering of the exceptions.
2139 /* Start the sequence numbering so that we will wrap it (just for in test_server_recv_out_of_order_data()
375 * The numbering scheme is aligned with Annex F of EN 300 707 v1.2.1 which
