Searched full:multiplexed (Results 1 – 20 of 20) sorted by relevance
10 /* SIUL2 Multiplexed Signal Configuration Register */12 /* SIUL2 Input Multiplexed Signal Configuration Register */35 /* Multiplexed Signal Configuration */ in pinctrl_configure_pin()43 /* Input Multiplexed Signal Configuration */ in pinctrl_configure_pin()
17 * - 7..15: Input Multiplexed Signal Configuration Register (IMCR) index18 * - 16..24: Multiplexed Signal Configuration Register (MSCR) index77 * @param mscr_idx Multiplexed Signal Configuration Register (MSCR) index79 * @param imcr_idx Input Multiplexed Signal Configuration Register (IMCR) index
16 Devices to be multiplexed.28 the multiplexer is ready for use (i.e. one of the [0, N-1] multiplexed
18 - Multiplexed or non-multiplexed22 - Multiplexed or non-multiplexed147 Note: Used for SRAMs, ROMs and asynchronous multiplexed153 Note: Only used for multiplexed NOR Flash memories.
15 /* SIUL2 Multiplexed Signal Configuration */38 /* SIUL2 Input Multiplexed Signal Configuration */
15 /* SIUL2 Multiplexed Signal Configuration */40 /* SIUL2 Input Multiplexed Signal Configuration */
62 * @return The index (>= 0) of the currently active multiplexed device on success76 * @retval -ENODEV If the multiplexed device at @p index is not ready
12 or V2bis like stm32F1 or stm32L1, where requests are multiplexed
19 e.g. if the SWD connections are multiplexed.
149 /* Same signal can be multiplexed to multiple I/O pins */
183 /* special case for LDOIO0, which is multiplexed with GPIO0 */ in axp192_enable()207 /* special case for LDOIO0, which is multiplexed with GPIO0 */ in axp192_disable()
48 - 32 Mbit/s SPI(3) multiplexed with I2S(2)
71 - 3x SPIs (2x with multiplexed half duplex I2S interface)
25 /* SIUL2 Multiplexed Signal Configuration Register (offset from port base) */
112 Table below lists the pin assignment of valid protocols that can be multiplexed on the Pmod_A146 Table below lists the pin assignment of valid protocols that can be multiplexed on the Pmod_B180 Table below lists the pin assignment of valid protocols that can be multiplexed on the Pmod_C
109 Table below lists the pin assignment of valid protocols that can be multiplexed on the ``Pmod_A``143 Table below lists the pin assignment of valid protocols that can be multiplexed on the ``Pmod_B``177 Table below lists the pin assignment of valid protocols that can be multiplexed on the ``Pmod_C``
736 messages are correctly multiplexed with shell output. Log messages from logger
235 The four external Analog Inputs are multiplexed to a single host
725 command set. Ideally all external commands are multiplexed through that single
