Searched full:measurements (Results 1 – 25 of 71) sorted by relevance
123
19 Enable/disable temperature measurements and set measurement mode.21 bool "Disable temperature measurements"23 bool "Temperature measurements in single shot mode"25 bool "Temperature measurements in continuous mode"32 Enable/disable relative humidity measurements and set measurement mode.34 bool "Disable relative humidity measurements"36 bool "Relative humidity measurements in single shot mode"38 bool "Relative humidity measurements in continuous mode"
86 prompt "Measurements per second"90 Number of measurements per second.
40 * @brief VEML7700 gain options for ambient light measurements.50 * @brief VEML7700 integration time options for ambient light measurements.90 * @brief Gain setting for ALS measurements (ALS_GAIN).96 * @brief Integration time setting for ALS measurements (ALS_IT).
39 * Define axis relation measurements.
22 Select sampling mode. In normal mode continuous measurements are88 Select standby time between measurements for the BME280 sensor.
10 sampling rate and polls the measurements with the same rate and11 displays the measurements along with a timestamp since startup.
39 addition the following input measurements are enabled per mode:53 allows a subset of the measurements to be enabled:60 3 | 1 1 | All Measurements per Mode [2:0]
24 the chip ID and the resolution of the measurements.
17 SHTC3 has an additional sleep mode that is entered between measurements.
8 measurements through a bidirectional serial digital signal. The
19 Validates the additional checksum byte for temperature measurements.
64 printk("Failed to fetch measurements (%d)\n", ret); in main()71 printk("Failed to get measurements (%d)\n", ret); in main()
19 /* PRATE register defines the time between proximity measurements21 * Formular: time between measurements = REG_VALUE * 88µs26 * WTIME Register defines the wait time between measurements.
10 for indoor air quality measurements. VOCs are often categorized as38 reported measurements of about 400 ppm eC02 and 0 ppb eTVOC.
20 too high, or may return invalid measurements if calibration has not
25 bool "Measurements disabled"
118 /* Heartrate measurements simulation */ in hrs_notify()150 /* Heartrate measurements simulation */ in main()
114 /* Heartrate measurements simulation */ in hrs_notify()149 /* Heartrate measurements simulation */ in main()
16 and angular rate measurements.
11 low power context + ADC measurements and entropy.
162 /* Heartrate measurements simulation */ in hrs_notify()192 /* Heartrate measurements simulation */ in test_con2_main()
24 * for power consumption measurements
13 When triggered mode is enabled the measurements are displayed at the
151 bool "Temperature measurements"
19 /* see "Accelerometer Measurements" section from register map description */30 /* see "Gyroscope Measurements" section from register map description */
