Searched full:initialization (Results 1 – 25 of 855) sorted by relevance
12345678910>>...35
21 * @defgroup sys_init System Initialization24 * Zephyr offers an infrastructure to call initialization code before `main`.25 * Such initialization calls can be registered using SYS_INIT() or26 * SYS_INIT_NAMED() macros. By using a combination of initialization levels and28 * initialization levels are described, in order, below:34 * specific initialization code.35 * - `PRE_KERNEL_1`: Executed in Kernel's initialization context, which uses44 * Initialization priority can take a value in the range of 0 to 99.53 * @brief Initialization function for init entries.55 * Init entries support both the system initialization and the device[all …]
21 NCT38xx GPIO driver initialization priority. The priority must be lower28 NCT38xx GPIO port device driver initialization priority. The priority43 NCT38XX alert handler initialization priority. This initialization
14 int "nPM6001 GPIO driver initialization priority"18 Initialization priority for the nPM6001 GPIO driver.
14 int "nPM1300 GPIO driver initialization priority"18 Initialization priority for the nPM1300 GPIO driver. It must be
17 SC18IM704 GPIO controller initialization priority.19 Note: Has to be greater than the parent SC18IM704 bridge initialization priority.
7 int "Board initialization priority"12 Board initialization priority. The board initialization must take
19 - "eSPI test - I/O initialization...complete"21 - "eSPI test - callbacks initialization... complete"22 - "eSPI test - Power initialization...complete"26 - "espi: eSPI test - callbacks initialization..."
28 bool "QSPI NOR flash feature during driver initialization"33 4-byte address support and so on during driver initialization. Disable34 it if QSPI NOR devices are not ready during driver initialization.
19 in those chips and at initialization configures them to work in33 int "Driver initialization priority"36 Device driver initialization priority.
9 * @brief Full C support initialization12 * Initialization of full C support: zero the .bss and call z_cstart().15 * initialization is performed.
5 int "Board initialization priority"8 Board initialization priority.
60 System clock source initialization waits until clock is available. In some64 system clock driver initialization but it may be less accurate. Option is71 System clock source initialization waits until clock is stable. When this73 driver initialization.
22 int "CC2520 initialization priority"25 Set the initialization priority number. Do not mess with it unless78 int "TI CC2520 crypto device initialization priority"82 Set the initialization priority number. Do not mess with it unless
19 are performed during the initialization of the SoC.66 int "MCR20A initialization priority"69 Set the initialization priority number. Do not mess with it unless
15 int "Initialization priority"18 OTM8009A display driver initialization priority.
14 int "nPM6001 Watchdog driver initialization priority"18 Initialization priority for the nPM6001 Watchdog driver.
14 int "nPM1300 Watchdog driver initialization priority"18 Initialization priority for the nPM1300 Watchdog driver.
7 int "Remap routine initialization priority"10 Initialization priority of the remap routine within the PRE_KERNEL1 level.
12 int "RV32M1 initialization priority"16 RV32M1 pin controller initialization priority.
12 int "Remap initialization priority"16 Initialization priority for the routine in charge of configuring the
17 int "NXP S32 eMIOS initialization priority"20 System initialization priority for NXP S32 eMIOS drivers.
9 * @brief Full C support initialization12 * Initialization of full C support: zero the .bss, copy the .data if XIP,16 * initialization is performed.
