Searched full:ground (Results 1 – 25 of 38) sorted by relevance
12
26 1 - Vout is loaded with 1 kOhm resistor to ground27 2 - Vout is loaded 100 kOhm resistor to ground28 3 - Vout is loaded with 500 kOhm resistor to ground
17 and ground, they are not mapped in the nexus.26 Reference Ground - GND GND - Reference Ground
25 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)42 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)53 JP1 pin 2 to GND (ground MEC172x XTAL1 pin)
23 nxp,ground-select:
34 assumed to be connected-ground, which usually means a pull-down resistance
70 # We use BT_BAP_STREAM as a common ground for audio, as that is set whenever
11 * at their 32-bit entry points to cover common ground.
18 Connect sensor CS pin high to enable I2C communication, SAO to ground for 0x18
50 ground and the white wire to the SCL pin, i.e. pin P19 on the edge connector.
54 * configuration which behaves like a switch that is either connected to ground
53 * Ground is on pin4
27 and a 100nF capacitor to ground for debouncing.
62 * Ground is on pin4
33 share a common ground.
32 share a common ground.
10 ground for both data transmission and device power supply.
23 /* Select Vin2. Vin1 is not used and tied to ground on this chip. Vin2 is from VDDA_1P8_IN. */
25 other dongle's RX pin. The ground connection is not needed. Both dongles must
33 #. Ensure your Zephyr board, and the LED strip share a common ground.
192 /* Select ground */ in regulator_nxp_vref_init()
77 ground. 32K_XP pin can not be used as a GPIO in this case.
10 number of small ground robotics useful sensors including chirp sensors for time of flight
51 * Course over ground un 10^-2 degree.
102 ground. 32K_XP pin can not be used as a GPIO in this case.
76 | 6 | GND | Ground pin | - |78 | 7 | GND | Ground pin | - |122 | 29 | GND | Ground pin | - |
