Home
last modified time | relevance | path

Searched full:extended (Results 1 – 25 of 408) sorted by relevance

12345678910>>...17

/Zephyr-Core-3.5.0/modules/
DKconfig.stm3224 Enable STM32Cube Extended Analog-to-Digital Converter (ADC) HAL
63 Enable STM32Cube Extended Cyclic redundancy check calculation unit
74 Enable STM32Cube Extended Cryptographic processor (CRYP) HAL module
85 Enable STM32Cube Extended Digital-to-analog converter (DAC) HAL module
101 Enable STM32Cube Extended Digital camera interface (DCM) HAL module
113 Enable STM32Cube Extended Digital filter for sigma delta modulators
131 Enable STM32Cube Extended Direct Memory Access controller (DMA) HAL
152 Enable STM32Cube Extended Ethernet (ETH) HAL module driver
157 Enable STM32Cube Extended interrupt and event controller (EXTI) HAL
179 Enable STM32Cube Extended Embedded Flash Memory (FLASH) HAL module
[all …]
/Zephyr-Core-3.5.0/drivers/flash/
DKconfig.stm3224 bool "Extended operation for flash write protection control"
28 Enables flash extended operation for enabling/disabling flash write
40 bool "Extended operation for flash readout protection control"
44 Enables flash extended operation for enabling/disabling flash readout
64 bool "Extended operation for blocking option and control registers"
67 Enables flash extended operations that can be used to disable access
DKconfig17 This option is selected by drivers that support flash extended
88 bool "API for extended flash operations"
92 Enables flash extended operations API. It can be used to perform
/Zephyr-Core-3.5.0/drivers/can/
DKconfig.stm3233 int "Maximum number of extended (29-bit) ID filters"
37 Defines the maximum number of filters with extended ID (29-bit)
40 One extended ID filter with mask occupies 1 of the 14 available
68 int "Maximum number of extended (29-bit) ID filters"
72 Defines the maximum number of filters with extended ID (29-bit)
/Zephyr-Core-3.5.0/samples/bluetooth/observer/
Dprj_extended.conf4 # Enable Extended Scanning
8 # Zephyr Bluetooth LE Controller needs 16 event buffers to generate Extended
12 # Set maximum scan data length for Extended Scanning in Bluetooth LE Controller
/Zephyr-Core-3.5.0/subsys/bluetooth/
DKconfig.adv8 bool "Extended Advertising and Scanning support"
12 Select this to enable Extended Advertising API support.
14 extended advertising data, and advertising on LE Coded PHY.
15 It enables support for receiving extended advertising data as a
27 If this option is not enabled the controller must support the extended
/Zephyr-Core-3.5.0/tests/drivers/can/api/src/
Dcommon.h43 * @brief Extended (29-bit) CAN IDs and masks used for testing.
70 * @brief Extended (29-bit) CAN ID frame 1.
75 * @brief Extended (29-bit) CAN ID frame 1.
85 * @brief Extended (29-bit) CAN ID RTR frame 1.
124 * @brief Extended (29-bit) CAN ID filter 1. This filter matches
130 * @brief Extended (29-bit) CAN ID filter 2. This filter matches
136 * @brief Extended (29-bit) CAN ID masked filter 1. This filter matches
142 * @brief Extended (29-bit) CAN ID masked filter 2. This filter matches
154 * @brief Extended (29-bit) CAN ID RTR filter 1. This filter matches
Dcommon.c44 * @brief Extended (29-bit) CAN ID frame 1.
54 * @brief Extended (29-bit) CAN ID frame 1.
74 * @brief Extended (29-bit) CAN ID RTR frame 1.
152 * @brief Extended (29-bit) CAN ID filter 1. This filter matches
162 * @brief Extended (29-bit) CAN ID filter 2. This filter matches
172 * @brief Extended (29-bit) CAN ID masked filter 1. This filter matches
182 * @brief Extended (29-bit) CAN ID masked filter 2. This filter matches
202 * @brief Extended (29-bit) CAN ID RTR filter 1. This filter matches
/Zephyr-Core-3.5.0/tests/bluetooth/df/connectionless_cte_chains/src/
Dcommon.c169 zassert_equal(err, 0, "Unexpected error during initialization of extended PDU, err: %d", in common_create_per_adv_chain()
254 * Expected fields in extended advertising header are provided by @p exp_ext_hdr_flags.
260 * @param exp_ext_hdr_flags Bitfield with expected extended header flags.
274 "Unexpected mode of extended advertising PDU: %" PRIu8, in common_validate_per_adv_pdu()
282 "Unexpected AdvA field in extended advertising header"); in common_validate_per_adv_pdu()
284 "Unexpected TargetA field in extended advertising header"); in common_validate_per_adv_pdu()
288 "Missing expected CteInfo field in extended advertising header"); in common_validate_per_adv_pdu()
293 "Unexpected CteInfo field in extended advertising header"); in common_validate_per_adv_pdu()
298 "Missing expected ADI field in extended advertising header"); in common_validate_per_adv_pdu()
303 "Unexpected ADI field in extended advertising header"); in common_validate_per_adv_pdu()
[all …]
/Zephyr-Core-3.5.0/drivers/interrupt_controller/
DKconfig.gd32_exti5 bool "GD32 Extended Interrupts and Events (EXTI) Controller"
9 Enable the GigaDevice GD32 Extended Interrupts and Events (EXTI)
/Zephyr-Core-3.5.0/samples/bluetooth/tmap_bms/src/
Dcap_initiator.c117 printk("Unable to create extended advertising set: %d\n", err); in setup_extended_adv()
150 /* Setup extended advertising data */ in setup_extended_adv_data()
161 printk("Failed to set extended advertising data: %d\n", err); in setup_extended_adv_data()
188 /* Start extended advertising */ in start_extended_adv()
191 printk("Failed to start extended advertising: %d\n", err); in start_extended_adv()
209 /* Stop extended advertising */ in stop_and_delete_extended_adv()
218 printk("Failed to stop extended advertising: %d\n", err); in stop_and_delete_extended_adv()
224 printk("Failed to delete extended advertising: %d\n", err); in stop_and_delete_extended_adv()
275 printk("Unable to setup extended advertiser: %d\n", err); in cap_initiator_setup()
293 printk("Unable to setup extended advertising data: %d\n", err); in cap_initiator_setup()
[all …]
/Zephyr-Core-3.5.0/drivers/memc/
Dmemc_stm32_nor_psram.c18 /** SRAM extended mode register offset, see FMC_Bank1E_R_BASE */
31 FMC_NORSRAM_EXTENDED_TypeDef *extended; member
43 hnor.Extended = config->extended; in memc_stm32_nor_init()
69 hsram.Extended = config->extended; in memc_stm32_psram_init()
169 .extended = (FMC_NORSRAM_EXTENDED_TypeDef *)(DT_REG_ADDR(DT_INST_PARENT(0))
/Zephyr-Core-3.5.0/samples/bluetooth/periodic_adv/src/
Dmain.c52 printk("Start Extended Advertising..."); in main()
55 printk("Failed to start extended advertising " in main()
77 printk("Stop Extended Advertising..."); in main()
80 printk("Failed to stop extended advertising " in main()
/Zephyr-Core-3.5.0/drivers/sensor/tmp112/
DKconfig19 bool "Allow to set extended mode at runtime"
22 When set extended mode can be selected using tmp112_attr_set
/Zephyr-Core-3.5.0/tests/bsim/bluetooth/host/adv/chain/tests_scripts/
Dadv_chain.sh5 # Validate Extended Advertising AD Data fragment operation, PDU chaining and
6 # Extended Scanning of chain PDUs
/Zephyr-Core-3.5.0/samples/drivers/can/babbling/
DKconfig15 bool "Use Extended (29-bit) CAN ID"
17 Babling node sends extended (29-bit) CAN ID frames.
/Zephyr-Core-3.5.0/tests/bsim/bluetooth/host/adv/periodic/src/
Dper_adv_advertiser.c91 printk("Creating extended advertising set..."); in create_per_adv_set()
113 printk("Creating connectable extended advertising set..."); in create_conn_adv_set()
126 printk("Starting Extended Advertising..."); in start_ext_adv_set()
129 printk("Failed to start extended advertising: %d\n", err); in start_ext_adv_set()
171 printk("Stopping Extended Advertising..."); in stop_ext_adv_set()
174 printk("Failed to stop extended advertising: %d\n", in stop_ext_adv_set()
199 printk("Delete extended advertising set..."); in delete_adv_set()
202 printk("Failed Delete extended advertising set: %d\n", err); in delete_adv_set()
/Zephyr-Core-3.5.0/samples/bluetooth/broadcaster_multiple/src/
Dbroadcaster_multiple.c98 /* Set extended advertising data */ in broadcaster_multiple()
107 /* Start extended advertising set */ in broadcaster_multiple()
111 printk("Failed to start extended advertising set %d " in broadcaster_multiple()
116 printk("Started Extended Advertising Set %d.\n", index); in broadcaster_multiple()
/Zephyr-Core-3.5.0/drivers/ieee802154/
Dieee802154_cc1200.h66 void *data, size_t length, bool extended, bool burst);
69 uint8_t addr, bool extended) in cc1200_read_single_reg() argument
73 if (z_cc1200_access_reg(dev, true, addr, &val, 1, extended, false)) { in cc1200_read_single_reg()
81 uint8_t addr, uint8_t val, bool extended) in cc1200_write_single_reg() argument
83 return z_cc1200_access_reg(dev, false, addr, &val, 1, extended, false); in cc1200_write_single_reg()
/Zephyr-Core-3.5.0/subsys/bluetooth/controller/
DKconfig.ll_sw_split144 to Extended Advertising mode, and restore it when switching back to
147 Advertising or switch between Legacy and Extended Advertising.
195 int "Maximum Extended Scanning Data Length"
199 Maximum Extended Scanning Data Length.
293 int "LE Extended Advertising Auxiliary Sets"
312 Enable support for Advertising Data chaining in Extended and
331 # Enable chaining in Extended Advertising
336 bool "Back-to-back transmission of extended advertising trains"
341 Enables transmission of AUX_CHAIN_IND in extended advertising train by
345 int "AUX Frame Space for back-to-back transmission of extended advertising trains"
[all …]
/Zephyr-Core-3.5.0/subsys/net/lib/coap/
DKconfig38 bool "Support for CoAP extended options"
40 This option enables the parsing of extended CoAP options length.
41 CoAP extended options length can be 2 byte value, which
47 int "CoAP extended options length value"
/Zephyr-Core-3.5.0/subsys/bluetooth/controller/ll_sw/
Dull_adv_internal.h12 /* Helper defined to check if Extended Advertising HCI commands used */
15 #define LL_ADV_CMDS_EXT 2 /* Only extended advertising cmd/evt allowed */
17 /* Helper function to check if Extended Advertising HCI commands used */
142 /* helper function to set/clear common extended header format fields */
149 /* helper function to set/clear common extended header format fields for
159 /* helper to initialize extended advertising PDU */
164 /* helper to add cte_info field to extended advertising header */
171 /* helper to get information whether ADI field is avaialbe in extended advertising PDU */
278 /* helper function to set/clear common extended header format fields
/Zephyr-Core-3.5.0/tests/bsim/bluetooth/host/adv/chain/
Dprj.conf27 # Maximum Extended Scanning buffer size
30 # Set maximum scan data length for Extended Scanning in Bluetooth LE Controller
/Zephyr-Core-3.5.0/samples/bluetooth/broadcaster_multiple/
DREADME.rst24 * A board with Bluetooth Low Energy with Extended Advertising support.
32 To test this sample use the Observer sample with Extended Scanning enabled,
/Zephyr-Core-3.5.0/subsys/net/l2/ieee802154/
Dieee802154_shell.c65 * Parse a string representing an extended address in ASCII HEX
68 * @param addr Extended address as a string.
69 * @param ext_addr Extended address in big endian byte ordering.
107 "Failed to parse extended address\n"); in cmd_ieee802154_associate()
196 pos += snprintk(buf + pos, buf_len - pos, "(extended) "); in print_coordinator_address()
451 "Failed to parse extended address\n"); in cmd_ieee802154_set_ext_addr()
458 "Could not set extended address\n"); in cmd_ieee802154_set_ext_addr()
463 "Extended address set\n"); in cmd_ieee802154_set_ext_addr()
484 "Could not get extended address\n"); in cmd_ieee802154_get_ext_addr()
499 "Extended address: %s\n", ext_addr); in cmd_ieee802154_get_ext_addr()
[all …]

12345678910>>...17