Searched full:disables (Results 1 – 25 of 139) sorted by relevance
123456
| /Zephyr-Core-3.6.0/tests/arch/arm/arm_thread_swap_tz/ |
| D | testcase.yaml | 10 # NOTE: this platform disables FPU access in TFM.
19 # NOTE: this platform disables FPU access in TFM.
|
| /Zephyr-Core-3.6.0/soc/arm/nxp_s32/s32k1/ |
| D | flash_configuration.c | 17 /* Flash security register (FSEC) enables/disables backdoor key access,
22 /* Flash nonvolatile option register (FOPT) enables/disables NMI,
|
| /Zephyr-Core-3.6.0/soc/arm/nxp_kinetis/ |
| D | flash_configuration.c | 18 /* Flash security register (FSEC) enables/disables backdoor key access,
23 /* Flash nonvolatile option register (FOPT) enables/disables NMI,
|
| /Zephyr-Core-3.6.0/tests/bsim/bluetooth/mesh/tests_scripts/priv_beacon/ |
| D | priv_proxy_gatt.sh | 10 # 0. Both TX and RX device disables SNB and GATT proxy, and enables
14 # 2. Both TX and RX device disables the scanner to prevent interferance
|
| D | priv_proxy_net_id_multi.sh | 10 # 0. TX device disables GATT proxy, adds a second network to the device
|
| D | priv_proxy_net_id.sh | 10 # 0. TX device disables GATT proxy and enables Private GATT proxy.
|
| D | priv_proxy_node_id.sh | 10 # 0. TX device disables GATT proxy and enables the Private Node
|
| /Zephyr-Core-3.6.0/dts/bindings/clock/ |
| D | st,stm32f3-rcc.yaml | 32 - 0: Disables the clock so the ADC can use AHB clock (synchronous mode)
53 - 0: Disables the clock so the ADC can use AHB clock (synchronous mode)
|
| D | atmel,sam-pmc.yaml | 8 controlling all system and user peripheral clocks. The PMC enables/disables
|
| /Zephyr-Core-3.6.0/samples/drivers/can/counter/boards/ |
| D | waveshare_open103z.overlay | 7 /* This board disables can1 by default in favor of USB. */
|
| /Zephyr-Core-3.6.0/cmake/modules/ |
| D | ccache.cmake | 3 # Use ccache if it is installed, unless the user explicitly disables
|
| /Zephyr-Core-3.6.0/include/zephyr/drivers/adc/ |
| D | adc_npcx_threshold.h | 74 * @brief Enables/Disables ADC threshold interruption.
81 * @param enable Enable or disables threshold interruption.
|
| /Zephyr-Core-3.6.0/dts/bindings/ethernet/ |
| D | adi,adin2111-phy.yaml | 25 Disables requirement of 2.4V TX operating mode in the AN advertisement.
|
| /Zephyr-Core-3.6.0/tests/bsim/bluetooth/mesh/tests_scripts/transport/ |
| D | fixed.sh | 12 # - disables the Relay feature, subscribes the model to the all-relays address and delivers the
|
| /Zephyr-Core-3.6.0/tests/bsim/bluetooth/mesh/tests_scripts/friendship/ |
| D | lpn_disable.sh | 10 # disables it again. Then we check that that the lpn node is actually in a
|
| /Zephyr-Core-3.6.0/drivers/ieee802154/ |
| D | Kconfig.dw1000 | 20 Zero value disables SNIFF mode.
|
| /Zephyr-Core-3.6.0/include/zephyr/mgmt/mcumgr/transport/ |
| D | smp_udp.h | 32 * @brief Disables the UDP SMP MCUmgr transport thread(s) which will close open sockets.
|
| /Zephyr-Core-3.6.0/subsys/usb/usb_c/ |
| D | usbc_stack.h | 69 /** Enables or Disables the Type-C state machine */
78 /** Enables or Disables the Policy Engine state machine */
91 /** Enables or Disables the Protocol Layer state machine */
|
| /Zephyr-Core-3.6.0/include/zephyr/usb/ |
| D | usbh.h | 121 * This function disables the USB host support.
132 * This function completely disables the USB host support.
|
| /Zephyr-Core-3.6.0/subsys/bluetooth/controller/include/ |
| D | ll.h | 285 /* Enables or disables CTE TX for periodic advertising */
290 /* Enables or disables CTE sampling in direction fingin connected mode. */
294 /* Enables or disables CTE request control procedure in direction fingin connected mode. */
298 /* Enables or disables CTE response control procedure in direction fingin connected mode. */
300 /* Enables or disables CTE sampling in periodic advertising scan */
|
| /Zephyr-Core-3.6.0/dts/bindings/sensor/ |
| D | microchip,tcn75a.yaml | 40 Oneshot sampling mode. Reduces power consumption, but disables triggering
|
| /Zephyr-Core-3.6.0/subsys/bluetooth/audio/ |
| D | Kconfig.has | 30 that can be registered. Setting this value to 0 disables Presets support.
|
| /Zephyr-Core-3.6.0/soc/arm/nordic_nrf/nrf54l/ |
| D | Kconfig.soc | 51 bool "Workaround that disables glitch detector"
|
| /Zephyr-Core-3.6.0/dts/bindings/pinctrl/ |
| D | nxp,lpc11u6x-pinctrl.yaml | 44 threshold for input pulses. 0 disables the filter. Only valid for
|
| /Zephyr-Core-3.6.0/arch/arc/core/dsp/ |
| D | Kconfig | 18 This option disables DSP block via resetting DSP_CRTL register.
|
123456
