Home
last modified time | relevance | path

Searched full:defining (Results 1 – 25 of 166) sorted by relevance

1234567

/Zephyr-latest/subsys/bluetooth/controller/ll_sw/nordic/hal/nrf5/
Dticker.h14 /* Macro defining the HW supported counter bits */
17 /* Macro defining the minimum counter compare offset */
20 /* Macro defining the max. counter update latency in ticks */
29 /* Macro defining the HW supported counter bits */
32 /* Macro defining the minimum counter compare offset */
35 /* Macro defining the max. counter update latency in ticks */
83 /* Macro defining the remainder resolution/range
89 /* Macro defining the margin for positioning re-scheduled nodes */
/Zephyr-latest/subsys/bluetooth/controller/ll_sw/openisa/hal/RV32M1/
Dticker.h13 /* Macro defining the minimum counter compare offset */
16 /* Macro defining the max. counter update latency in ticks */
22 /* Macro defining the HW supported counter bits */
68 /* Macro defining the remainder resolution/range
74 /* Macro defining the margin for positioning re-scheduled nodes */
/Zephyr-latest/tests/bluetooth/controller/mock_ctrl/include/hal/
Dticker_vendor_hal.h12 /* Macro defining the minimum counter compare offset */
15 /* Macro defining the max. counter update latency in ticks */
21 /* Macro defining the HW supported counter bits */
62 /* Macro defining the remainder resolution/range
68 /* Macro defining the margin for positioning re-scheduled nodes */
/Zephyr-latest/drivers/interrupt_controller/
DKconfig.mtk_adsp9 defining valid interrupts.
/Zephyr-latest/cmake/linker/
Dtarget_template.cmake8 # defining these macros themselves.
/Zephyr-latest/doc/kernel/iterable_sections/
Dindex.rst7 which can be used for defining iterable areas of equally-sized data structures,
13 Iterable section elements are typically used by defining the data structure and
/Zephyr-latest/soc/nxp/s32/common/
Dcmsis_rtos_v2_adapt.h11 * The HAL is defining these symbols already. To avoid interference
/Zephyr-latest/boards/st/nucleo_l552ze_q/
DKconfig.defconfig10 # Not defining LIBC malloc arena has the effect of declaring all available RAM
/Zephyr-latest/samples/boards/google/twinkie_v2/pda/src/
Dmeas.c27 /* Structure defining an ADC sampling sequence */ in meas_vbus_v()
60 /* Structure defining an ADC sampling sequence */ in meas_vbus_c()
/Zephyr-latest/dts/bindings/pinctrl/
Dnxp,imx-iomuxc-scu.yaml19 This is an array of values defining the pin mux selection
Dnxp,imx-iomuxc.yaml29 An array of values defining the pin mux selection, in the following format:
39 An array of values defining the GPR bit write required, if one exists.
/Zephyr-latest/samples/net/cloud/tagoio_http_post/
Dprj.conf5 # Default use minimal libc and with COMMON_LIBC_MALLOC_ARENA_SIZE defining
/Zephyr-latest/boards/st/stm32l562e_dk/
DKconfig.defconfig35 # Not defining LIBC malloc arena has the effect of declaring all available RAM
/Zephyr-latest/include/zephyr/drivers/i3c/
Dccc.h465 * @brief Defining byte values for ENTTM.
549 * @brief Defining byte values for GETSTATUS Format 2.
558 /** Invalid defining byte. */
585 * Defining Byte 0x00: TGTSTAT
592 * Defining Byte 0x91: PRECR
699 * @brief Enum for I3C Get Max Data Speed (GETMXDS) Format 3 Defining Byte Values.
711 /** Invalid defining byte. */
745 * Defining Byte 0x00: WRRDTURN
752 * Defining Byte 0x91: CRHDLY
793 /** Get Max Data Speed (GETMXDS) - maxWr - Optional Defining Byte Support. */
[all …]
/Zephyr-latest/boards/native/native_sim/
Dboard_soc.h14 * Device code may rely on the soc.h defining some things (like the interrupts
/Zephyr-latest/samples/basic/blinky/
DREADME.rst50 You will see a build error at the source code line defining the ``struct
86 - See :dtcompatible:`gpio-leds` for more information on defining GPIO-based LEDs
/Zephyr-latest/dts/bindings/flash_controller/
Dnuvoton,npcx-fiu-qspi.yaml5 Properties defining the NPCX Quad-SPI peripheral of Flash Interface Unit (FIU).
Dnordic,nrf-qspi.yaml5 Properties defining the interface for the Nordic QSPI peripheral.
/Zephyr-latest/drivers/mbox/
DKconfig14 # overridden (by defining symbols in multiple locations)
/Zephyr-latest/arch/arm/core/mpu/
Darm_core_mpu_dev.h59 * allocated memory regions, defining a region for a thread stack
61 * defining the thread stack and an additional one for partitioning
82 * allocated memory regions, defining a region for a supervisor
84 * configured; one for defining the stack guard and an additional
/Zephyr-latest/samples/drivers/i2s/output/
DREADME.rst20 The I2S device to be used by the sample is specified by defining
/Zephyr-latest/drivers/mdio/
DKconfig26 # overridden (by defining symbols in multiple locations)
/Zephyr-latest/samples/drivers/audio/dmic/
DREADME.rst18 The device to be used by the sample is specified by defining a devicetree node
/Zephyr-latest/boards/native/native_posix/
Dboard_soc.h13 * Device code may rely on the soc.h defining some things (like the interrupts
/Zephyr-latest/boards/native/nrf_bsim/
Dboard_soc.h13 * Device code may rely on the soc.h defining some things (like the interrupts

1234567