Searched full:consumption (Results 1 – 25 of 168) sorted by relevance
1234567
/Zephyr-Core-3.7.0/drivers/sensor/bosch/bme280/ |
D | Kconfig | 37 lead to more accurate readings, but higher power consumption. 55 lead to more accurate readings, but higher power consumption. 73 lead to more accurate readings, but higher power consumption. 91 Higher values lead to lower power consumption.
|
/Zephyr-Core-3.7.0/drivers/sensor/bosch/bme680/ |
D | Kconfig | 24 lead to more accurate readings, but higher power consumption. 42 lead to more accurate readings, but higher power consumption. 60 lead to more accurate readings, but higher power consumption.
|
/Zephyr-Core-3.7.0/drivers/sensor/infineon/dps310/ |
D | Kconfig | 23 lead to more accurate readings, but higher power consumption. 47 lead to more accurate readings, but higher power consumption.
|
/Zephyr-Core-3.7.0/samples/boards/stm32/power_mgmt/serial_wakeup/ |
D | README.rst | 58 target to reach low power consumption. 60 to get back to normal mode and reach low power consumption. 74 Optimal configuration for low power consumption 77 In order to reach lower power consumption numbers following parameters should be taken
|
/Zephyr-Core-3.7.0/boards/silabs/radio_boards/ |
D | index.rst | 40 - Advanced Energy Monitor providing real-time information about energy consumption at up to 10 ksps 52 - Advanced Energy Monitor providing real-time information about energy consumption at up to 100 ksps
|
/Zephyr-Core-3.7.0/samples/boards/mec15xxevb_assy6853/power_management/ |
D | prj.conf | 10 # Enable additional drivers to evaluate power consumption without activity
|
/Zephyr-Core-3.7.0/dts/bindings/sensor/ |
D | vishay,vcnl36825t.yaml | 32 Higher values yield lower power consumption. 61 Higher values increase accuracy and power consumption.
|
D | adi,adxl362.yaml | 21 This mode is intended for extremely low power consumption,
|
D | microchip,tcn75a.yaml | 40 Oneshot sampling mode. Reduces power consumption, but disables triggering
|
/Zephyr-Core-3.7.0/soc/atmel/sam0/common/ |
D | Kconfig.saml2x | 81 to avoid unexpected behavior and increased current consumption. To 82 further reduce power consumption, radio can be kept in reset state by
|
/Zephyr-Core-3.7.0/dts/bindings/pinctrl/ |
D | nuvoton,npcx-leakage-io.yaml | 15 property at the board level DT file to save more power consumption.
|
/Zephyr-Core-3.7.0/drivers/sensor/st/stm32_digi_temp/ |
D | Kconfig | 16 sensors differ in precision, accuracy and power consumption. Users
|
/Zephyr-Core-3.7.0/soc/atmel/sam/common/ |
D | soc_poweroff.c | 11 * achieves the lowest possible power consumption. Wakeup from this mode
|
D | soc_sam4l_poweroff.c | 11 * achieves the lowest possible power consumption. Wakeup from this mode
|
/Zephyr-Core-3.7.0/soc/espressif/esp32/ |
D | poweroff.c | 17 * to minimize current consumption. in z_sys_poweroff()
|
/Zephyr-Core-3.7.0/subsys/ipc/ipc_service/backends/ |
D | Kconfig.icmsg_me | 14 reduce RAM consumption in your application.
|
/Zephyr-Core-3.7.0/scripts/ |
D | requirements-extras.txt | 21 # can be used to sign a Zephyr application binary for consumption by a bootloader
|
/Zephyr-Core-3.7.0/soc/st/stm32/stm32u5x/ |
D | Kconfig | 30 SRAMs can be totally or partially switched off to further reduce consumption.
|
/Zephyr-Core-3.7.0/drivers/counter/ |
D | Kconfig.stm32_rtc | 33 The config increases power consumption.
|
/Zephyr-Core-3.7.0/soc/espressif/esp32c6/ |
D | Kconfig | 37 down when PHY is disabled. Enabling this setting reduces power consumption
|
/Zephyr-Core-3.7.0/soc/espressif/esp32c3/ |
D | Kconfig | 43 down when PHY is disabled. Enabling this setting reduces power consumption
|
/Zephyr-Core-3.7.0/soc/st/stm32/common/ |
D | pm_debug_swj.c | 18 * When debug access is not needed and in case power consumption performance is
|
/Zephyr-Core-3.7.0/drivers/sensor/bosch/bmi323/ |
D | Kconfig | 22 consumption, otherwise it is resumed when initialized. When resumed,
|
/Zephyr-Core-3.7.0/drivers/sensor/sensirion/sht3xd/ |
D | Kconfig | 60 noise level and energy consumption.
|
/Zephyr-Core-3.7.0/subsys/lorawan/services/ |
D | Kconfig | 119 reduce memory consumption. 140 reduce memory consumption.
|
1234567