Searched full:consecutive (Results 1 – 25 of 100) sorted by relevance
1234
64 1-> 1 consecutive proximity value out of threshold range fires an interrupt65 2-> 2 consecutive proximity values out of threshold range fires an interrupt
35 The number of consecutive samples that must agree prior to the input
28 in which N consecutive samples with same value are needed to validate
31 consecutive-frames (CF) as required. The FF contains information about the length of34 postpone, or accept the following consecutive frames.
22 # Required to handle large number of consecutive connections,
16 description: Number of consecutive pages with size pages-size bytes
31 than the consecutive ones. Usually, the first sector is marked as 0a
92 and number of consecutive skips did not exceeded101 was less than configured threshold. If number of consecutive skips
45 int "Cr timeout [ms] (timeout for consecutive frames)"49 Cr (receiver consecutive frame) timeout.
16 #define ISOTP_PCI_CF 0x02 /* Consecutive frame */
70 consecutive data exceed the configured threshold (config in DT).
8 # 1. Send a message from 3 different consecutive nodes starting from address 100;
49 # consecutive 32-byte loads and stores. Saving and restoring the Advanced SIMD
128 Number of consecutive integration cycles for which the data samples
54 * - It shall have no more than six consecutive zeros or ones.129 /* It shall have no more than six consecutive zeros or ones. */ in util_aa_le32()267 * - Set the value that is 3 times the handle so that consecutive values in util_saa_le32()
55 * - It shall have no more than six consecutive zeros or ones.130 /* It shall have no more than six consecutive zeros or ones. */ in util_aa_le32()
75 ISO 11898-1 (recovery after 128 occurrences of 11 consecutive
62 Mininum number of consecutive 32KHz pulses that pass all monitor tests
39 /** SPI delay before SPCK and between consecutive transfer. */
60 Base of the two consecutive registers from the UICR customer
38 * If a sensor has batched data where two consecutive readings differ by
28 Peak Acceleration between two consecutive sample fetches.
29 * binary inversion of fcb->f_erase_value to avoid it matching a 4 consecutive
27 * in the same place as before (when true) or as consecutive ones (otherwise).33 * If a given driver uses some dedicated hardware timer to trigger consecutive
81 /* The sample interval between consecutive samplings. Some drivers require304 /* Start consecutive samplings as fast as possible. */ in test_task_asynchronous_call()458 /* Start consecutive samplings as fast as possible. */ in test_task_repeated_samplings()
