Searched full:communicate (Results 1 – 25 of 141) sorted by relevance
123456
9 MDIO is a bus that is commonly used to communicate with ethernet PHY devices.10 Many ethernet MAC controllers also provide hardware to communicate over MDIO
109 This is the port number used by the Host and EC to communicate over136 This is the port number used by the Host and EC to communicate over153 This is the port number used by the Host and EC to communicate over164 This is the port number used by the Host and EC to communicate over
18 This is the port size used by the Host and EC to communicate over28 This is the port size used by the Host and EC to communicate over
91 This is the port size used by the Host and EC to communicate over99 This is the port size used by the Host and EC to communicate over
10 Enable Zephyr to communicate with Lower exception levels by73 Enable ARM SiP SVC service shell support to communicate with EL3/EL2
9 * the SPI driver being used to communicate with the device, cannot transceive
23 Number of allowed clients that can communicate with lower layer.
14 The WAKEn pin is asserted to communicate with the sensor. The
11 RISC-V target to communicate and use the Input/Output facilities on
27 Say Y here if you want Zephyr to communicate with system firmware
16 can communicate with other IP networks.
12 Configuration Client can communicate with to change the node configuration. In some
13 node. The Configuration Client model may communicate with servers on other
21 target node. The Private Beacon Client model may communicate with servers on
5 Communicate with another "cell" in the Jailhouse hypervisor using IVSHMEM Ethernet.10 This application demonstrates how to use IVSHMEM Ethernet to communicate with90 Now you can run Zephyr and Linux shell commands to communicate between
181 LOG_INF("Waiting for host to be ready to communicate"); in otPlatUartEnable()183 /* Data Terminal Ready - check if host is ready to communicate */ in otPlatUartEnable()197 /* Data Set Ready - the NCP SoC is ready to communicate */ in otPlatUartEnable()
5 Communicate with a PS/2 mouse.
43 communicate to the QEMU gateway, and any data intended for the host machine84 dynamically generated ports cannot communicate with external network.
104 stdout, _ = process.communicate(timeout=self._flashing_timeout)179 self._serial_pty_proc.communicate(timeout=self.base_timeout)259 stdout, stderr = proc.communicate(timeout=timeout)268 proc.communicate(timeout=timeout)
47 Use SPI bus to communicate with PHY
17 * to communicate with mx25, when qspi is not used, to avoid rerouting clock
4 Use a cellular modem to communicate with a UDP server.
14 Only one client may be present on the bus. Client can communicate with several
21 subevents and response slots, to that they can communicate with the
23 This driver allows modem drivers to communicate over UART with custom43 This driver allows modem drivers to communicate with an interface
