Searched full:capacitor (Results 1 – 11 of 11) sorted by relevance
| /Zephyr-latest/dts/bindings/regulator/ |
| D | cirrus,cp9314.yaml | 11 cirrus,initial-switched-capacitor-mode = "2:1";
34 cirrus,initial-switched-capacitor-mode:
40 Desired switched capacitor ratio set at initialization. This entry will overwrite
|
| /Zephyr-latest/dts/bindings/input/ |
| D | st,stmpe811.yaml | 54 Panel driver settling time (microseconds). For large panels (> 6"), a capacitor of 10 nF
57 around 1 ms. When a larger capacitor is used, this value should be changed, as it can
75 If no capacitor, or a smaller capacitor is used, this value can be lowered to
|
| /Zephyr-latest/tests/drivers/gpio/gpio_basic_api/ |
| D | Kconfig | 13 The pin selected may connect with a capacitor so we need
|
| /Zephyr-latest/dts/bindings/sensor/ |
| D | aosong,dht.yaml | 9 DHT11 uses a polymer humidity capacitor with NTC thermistor; the
|
| /Zephyr-latest/tests/drivers/build_all/regulator/ |
| D | i2c.dtsi | 98 cirrus,initial-switched-capacitor-mode = "2:1";
|
| /Zephyr-latest/samples/boards/espressif/light_sleep/ |
| D | README.rst | 28 and a 100nF capacitor to ground for debouncing.
|
| /Zephyr-latest/drivers/ethernet/ |
| D | dsa_ksz8xxx.c | 359 * 2) There may be a link-up issue in the capacitor AC coupling mode for port
370 * connection, or port to port with capacitor AC coupling connection, the signal
381 * solve the issue for all type of the short cables and the capacitor AC
407 * connection with the capacitor AC coupling mode.
498 * For the wider bandwidth cables or on-board capacitor AC coupling
510 * or connect two ports directly through capacitors for a capacitor
|
| /Zephyr-latest/soc/nordic/nrf54l/ |
| D | soc.c | 69 * where CAPACITANCE is the desired capacitor value in pF, holding any in nordicsemi_nrf54l_init()
|
| /Zephyr-latest/soc/nordic/nrf53/ |
| D | Kconfig | 322 for each capacitor, 15 to get 7.5 pF, and so on.
|
| D | soc.c | 539 * where CAPACITANCE is the desired capacitor value in pF, holding any in nordicsemi_nrf53_init()
|
| /Zephyr-latest/boards/ronoth/lodev/doc/ |
| D | s76s.rst | 146 …rs a reduced touch sensing sensitivity. It is thus recommended to use it as sampling capacitor I/O.
|
