Searched full:by (Results 1 – 17 of 17) sorted by relevance
3 # This file describes the settings to be used by the documentation system29 # The PROJECT_NAME tag is a single word (or a sequence of words surrounded by82 # documentation generated by doxygen is written. Doxygen will use this97 # documentation generated by doxygen is written. Doxygen will use this205 # interpreted by doxygen.230 # By default Python docstrings are displayed as preformatted text and doxygen's231 # special commands cannot be used. By setting PYTHON_DOCSTRING to NO the252 # uses this value to replace tabs by spaces in code fragments.268 # escape them by means of a backslash (\), this can lead to conflicts with the314 # language is one of the parsers supported by doxygen: IDL, Java, JavaScript,[all …]
78 * LSB first send out, it should be supported by hardware92 * The parameter is bitmask of CS pin been controlled by SPI241 * it will be detected by hardware, master detect the CS pin deactive while263 uint32_t is_available : 1; /** 1:available 0:used by host **/280 uint32_t is_available : 1; /** 1:available 0:used by host **/
39 * An ipc busy bit is cleared by peer46 * An ipc message is received by peer
356 * @param[OUT] comp_len Length of data read completed by this call.681 * @param[out] cfg pointer to configuration structure populated by this755 * The mask can be generated by OR ing the parameters of sedi_uart_lc_t.826 * @param[OUT] p_len pointer to int which would be populated by length.1097 * @param[out] cfg pointer to iseis_uart_rs485_config_t populated by the call.1152 * @param[out] cfg pointer to sedi_uart_9bit_config_t populated by this call.
256 uint32_t is_available : 1; /** 1:available 0:used by host **/452 * -1 when slave is not addressed by master
115 uint32_t is_available : 1; /** 1:available 0:used by host **/
281 /**< Suspend: context should be saved and restored by driver */
248 uint32_t is_available : 1; /** 1:available 0:used by host **/
26 * \brief D-Cache Clean and Invalidate by address49 * \brief D-Cache Clean by address
136 * \brief check if a device is owned by SoC itself
15 THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND
44 git commit -s -m "Update SEDI docs, triggered by ${git_hash}"
27 /* weak PM functions used by SEDI drivers when SEDI PM driver is not enabled */
24 /* Disable debug print by default */92 * triggered by both-edge, and temporarily set each gpio pin to the single
216 /* Clear all error interrupt by read*/ in lld_spi_interrupt_clear()1082 /* the SPI transaction may interrupted by some other events between Tx/Rx dma in sedi_spi_dma_transfer()
89 * This structure is only intended to be used by the sedi_uart_save_context and635 /* Clear interrupt settings set by bootloader uart init.*/ in sedi_uart_set_config()
686 /* sent last data by interrupt, with stop if not pending */ in callback_dma_transfer()
