Home
last modified time | relevance | path

Searched full:appropriate (Results 1 – 25 of 258) sorted by relevance

1234567891011

/Zephyr-latest/boards/cdns/xt-sim/doc/
Dindex.rst124 appropriate values.
141 a. Select appropriate core (example ``hifi3_bd5 core``)
143 a. Set ``Hardware clock cycles per second`` to appropriate value
144 b. Set ``The path to Xtensa tool`` to appropriate value
145 c. Set ``The version of Xtensa tool`` to appropriate version
146 d. Set ``Xtensa build directory`` to appropriate value
/Zephyr-latest/dts/bindings/regulator/
Dnxp,vref.yaml28 appropriate device data sheet, in microseconds.
35 appropriate device data sheet, in microseconds.
/Zephyr-latest/samples/tfm_integration/psa_crypto/src/
Dutil_app_cfg.h45 * @return #PSA_SUCCESS on success, otherwise a appropriate psa_status_t code.
57 * @return #PSA_SUCCESS on success, otherwise a appropriate psa_status_t code.
/Zephyr-latest/soc/nordic/common/vpr/
DKconfig.sysbuild11 It is based on samples/basic/minimal with an appropriate snippet.
/Zephyr-latest/samples/subsys/mgmt/hawkbit/
DKconfig25 it is appropriate to update now or later.
/Zephyr-latest/samples/subsys/mgmt/updatehub/
DKconfig11 it is appropriate to update now or later.
/Zephyr-latest/dts/bindings/gpio/
Dnxp,lpc-gpio-port.yaml29 or "int-b" if interrupt support is desired, and the appropriate IRQ number
/Zephyr-latest/samples/sensor/bmi270/src/
Dmain.c39 /* Set sampling frequency last as this also sets the appropriate in main()
60 /* Set sampling frequency last as this also sets the appropriate in main()
/Zephyr-latest/cmake/modules/
DFindDeprecated.cmake109 "Please use '${LINKER}/linker_flags.cmake' and define the appropriate "
125 "Please use '${LINKER}/linker_flags.cmake' and define the appropriate "
141 "Please use '${LINKER}/linker_flags.cmake' and define the appropriate "
Darch_v2.cmake37 "an appropriate SoC in Kconfig, SoC=${CONFIG_SOC}, and that the SoC "
/Zephyr-latest/dts/bindings/sensor/
Daosong,dht.yaml26 signals. A pull up may be appropriate.
Djedec,jc-42.4-temp.yaml20 sensor, and is open-drain. A pull-up may be appropriate. The
/Zephyr-latest/drivers/watchdog/
Dwdt_iwdg_stm32.h17 * an appropriate reference manual and look for chapter called:
Dwdt_wwdg_stm32.h18 * an appropriate reference manual and look for chapter called:
/Zephyr-latest/samples/boards/nordic/dynamic_pinctrl/
DREADME.rst19 revisions, the firmware needs to select the appropriate routing when the
22 The Dynamic Pin Control (nRF) sample allows you to select the appropriate routing.
/Zephyr-latest/subsys/net/lib/prometheus/
Dhistogram.c29 /* find appropriate bucket */ in prometheus_histogram_observe()
/Zephyr-latest/soc/nordic/nrf92/
DKconfig.soc37 # The SiP selects the actual SoC complete with engineer revision and appropriate CPU
/Zephyr-latest/include/zephyr/linker/
Dintlist.ld19 * an appropriate number of instances of struct _isr_list. See
/Zephyr-latest/doc/hardware/arch/
Drisc-v.rst26 are available on a given platform, by setting the appropriate ``CONFIG_RISCV_ISA_*``
/Zephyr-latest/doc/services/tfm/
Dtestsuites.rst9 These test suites can be run from Zephyr via an appropriate sample application
/Zephyr-latest/cmake/compiler/arcmwdt/
Dtarget.cmake48 # architectures. __MW_ASM_RV_MACRO__ allows to select appropriate compilation branch.
/Zephyr-latest/samples/subsys/shell/devmem_load/
DREADME.md38 … from the console or send it from the host PC (replace `ttyX` with the appropriate one for your UA…
/Zephyr-latest/boards/ti/common/
Dlaunchxl_sky13317.dtsi10 * appropriate RF signal port based on the currently-used PHY.
/Zephyr-latest/tests/bluetooth/df/connectionless_cte_rx/src/
Dcommon.c54 /* Below code makes fake sync enable and provides appropriate handle value to in common_create_per_sync_set()
/Zephyr-latest/
DCODE_OF_CONDUCT.md42 acceptable behavior and will take appropriate and fair corrective action in
49 decisions when appropriate.

1234567891011