Searched full:vstart (Results 1 – 6 of 6) sorted by relevance
| /Zephyr-latest/dts/bindings/stepper/adi/ |
| D | adi,trinamic-ramp-generator.yaml | 7 vstart:
13 Normally, set VSTOP ≥ VSTART! VSTART may be
21 First acceleration between VSTART and V1 in [µsteps/ta²](unsigned)
43 Motion ramp target velocity in [µsteps/t] (for positioning ensure VMAX ≥ VSTART) (unsigned)
67 Attention: Set VSTOP ≥ VSTART!
78 seconds. This setting avoids excess acceleration e.g. from VSTOP to -VSTART.
|
| D | adi,tmc5041.yaml | 41 vstart = <10>;
98 - vstart
|
| /Zephyr-latest/include/zephyr/drivers/stepper/ |
| D | stepper_trinamic.h | 66 uint32_t vstart; member
84 COND_CODE_1(DT_PROP_EXISTS(node, vstart), \
85 BUILD_ASSERT(IN_RANGE(DT_PROP(node, vstart), TMC_RAMP_VSTART_MIN, \
86 TMC_RAMP_VSTART_MAX), "vstart out of range"), ()); \
136 .vstart = DT_PROP(node, vstart), \
|
| /Zephyr-latest/drivers/video/ |
| D | ov7725.c | 426 uint16_t hstart, vstart, hsize; in ov7725_set_fmt() local
489 vstart = 0x07U << 1U; in ov7725_set_fmt()
495 ov7725_write_reg(&cfg->i2c, OV7725_VSTART, vstart >> 1U); in ov7725_set_fmt()
500 ((vstart & 1U) << 6U) | in ov7725_set_fmt()
|
| D | ov2640.c | 89 #define VSTART 0x19 macro
355 { VSTART, 0x01 }, /* UXGA=0x01, SVGA/CIF=0x00 */
|
| /Zephyr-latest/drivers/stepper/adi_tmc/ |
| D | adi_tmc5041_stepper_controller.c | 549 err = tmc5041_write(config->controller, TMC5041_VSTART(config->index), ramp_data->vstart); in tmc5041_stepper_set_ramp()
|
