Searched full:pad1 (Results 1 – 10 of 10) sorted by relevance
| /Zephyr-latest/soc/nxp/rw/ |
| D | flash_config.h | 53 #define FC_FLEXSPI_LUT_SEQ(cmd0, pad0, op0, cmd1, pad1, op1) \ argument
55 FLEXSPI_LUT_OPERAND1(op1) | FLEXSPI_LUT_NUM_PADS1(pad1) | FLEXSPI_LUT_OPCODE1(cmd1))
|
| /Zephyr-latest/dts/bindings/pinctrl/ |
| D | atmel,sam0-pinctrl.yaml | 10 to route SERCOM0 as UART were RX to pin PAD1 and enable the pull-up resistor
|
| /Zephyr-latest/drivers/sensor/st/iis328dq/ |
| D | iis328dq_trigger.c | 50 /* route DRDY to PAD1 */ in iis328dq_enable_int()
104 /* route both internal interrupts to PAD1 */ in iis328dq_enable_int()
|
| /Zephyr-latest/soc/nxp/imxrt/ |
| D | flexspi_nor_config.h | 65 #define FLEXSPI_LUT_SEQ(cmd0, pad0, op0, cmd1, pad1, op1) \ argument
67 FLEXSPI_LUT_OPERAND1(op1) | FLEXSPI_LUT_NUM_PADS1(pad1) | FLEXSPI_LUT_OPCODE1(cmd1))
|
| /Zephyr-latest/include/zephyr/xen/public/ |
| D | xen.h | 253 uint8_t pad1[2]; member
255 int8_t pad1[3]; member
|
| D | domctl.h | 101 uint16_t pad1; member
|
| /Zephyr-latest/include/zephyr/arch/x86/ia32/ |
| D | thread.h | 108 unsigned short pad1; /* 2 : N/A */ member
|
| /Zephyr-latest/arch/x86/zefi/ |
| D | efi.h | 184 uint8_t Pad1; member
|
| /Zephyr-latest/subsys/net/ip/ |
| D | ipv6.c | 232 * Pad1 which has only a type without any length in ipv6_handle_ext_hdr_options()
246 NET_DBG("PAD1 option"); in ipv6_handle_ext_hdr_options()
|
| /Zephyr-latest/include/zephyr/drivers/can/ |
| D | can_mcan.h | 918 uint32_t pad1: 18; member
959 uint32_t pad1: 18; member
1000 uint32_t pad1: 18; member
|
