Home
last modified time | relevance | path

Searched full:otp (Results 1 – 25 of 56) sorted by relevance

123

/Zephyr-latest/samples/boards/nxp/mimxrt595_evk/system_off/
DREADME.rst51 OTP Fuse setting to wake from Deep Power Down and reset flash
72 the One-Time-Programmable (OTP) fuses in the MCU. The steps below detail
73 how program the OTP BOOT_CFG1 fuses to use GPIO pin PIO4_5 as the flash
77 using this MCU may use a different GPIO pin, and the setting in the OTP
79 fuses, it is best to write the OTP shadow registers first and confirm
80 the operation. Then program the OTP fuses after confirming the correct
81 settings. For more details on OTP fuses and shadow registers, refer to
82 the Reference Manual for this MCU, and the OTP Fuse Map spreadsheet
90 program the OTP fuses. To download, go to https://www.nxp.com/mcuboot,
93 Steps to program OTP fuses on MIMXRT595-EVK
/Zephyr-latest/boards/microchip/mec172xevb_assy6906/support/
Dspi_cfg.txt11 ; is disabled. If PlatformID is enabled in OTP Boot-ROM will check the image
12 ; BoardID value with an OTP PlatformID value. Load is aborted if the ID's do
/Zephyr-latest/boards/microchip/mec172xmodular_assy6930/support/
Dspi_cfg.txt11 ; is disabled. If PlatformID is enabled in OTP Boot-ROM will check the image
12 ; BoardID value with an OTP PlatformID value. Load is aborted if the ID's do
Dspi_cfg_4MBit.txt11 ; is disabled. If PlatformID is enabled in OTP Boot-ROM will check the image
12 ; BoardID value with an OTP PlatformID value. Load is aborted if the ID's do
/Zephyr-latest/dts/bindings/display/
Dsolomon,ssd16xx-common.yaml47 defaults loaded from the controllers OTP memory.
51 loaded from OTP if supported by the device.
Dultrachip,uc81xx-common.yaml29 defaults loaded from the controllers OTP memory.
36 to use the reset values from OTP instead of the values specified
/Zephyr-latest/dts/common/nordic/
Dnrf5340_cpuapp_partition.dtsi23 * 0x000f_6000 OTP / NV counters area (8 KB)
61 label = "tfm-otp";
Dnrf91xx_partition.dtsi23 * 0x000f_6000 OTP / NV counters area (8 KB)
61 label = "tfm-otp";
/Zephyr-latest/drivers/regulator/
Dregulator_cp9314.c224 /* OTP memory errata patch for OTP v1. Corrects trim errata. */
493 * The PTE_2 field in the PTE_REG_2 register contains the value representing the OTP in regulator_cp9314_otp_init()
494 * burned on the CP9314 device. The PTE_2 values in relation to the OTP table names in regulator_cp9314_otp_init()
497 * OTP-1 = 0x0, OTP-2 = 0x1, OTP-3 = 0x3, OTP-4 = 0x4 in regulator_cp9314_otp_init()
/Zephyr-latest/boards/nxp/mimxrt595_evk/
Dboard.c15 /* OTP fuse index. */
314 * flash reset pin. We can control this behavior using the OTP shadow in mimxrt595_evk_init()
323 * NOTE: Reading OTP fuses requires a VDDCORE voltage of at least 1.0V in mimxrt595_evk_init()
333 * Production devices have 96M trim values programmed in OTP fuses. in mimxrt595_evk_init()
/Zephyr-latest/tests/bluetooth/qualification/
DICS_Zephyr_Bluetooth_Host.bqw642 <Layer Layer="OTP">
644 <Feature>OTP 9/13</Feature>
645 <Feature>OTP 9/6</Feature>
646 <Feature>OTP 6/7</Feature>
647 <Feature>OTP 6/9</Feature>
648 <Feature>OTP 8/19</Feature>
649 <Feature>OTP 9/18</Feature>
650 <Feature>OTP 3/2</Feature>
651 <Feature>OTP 6/1</Feature>
652 <Feature>OTP 6/13</Feature>
[all …]
/Zephyr-latest/boards/nxp/mimxrt685_evk/
Dinit.c50 * flash reset pin. We can control this behavior using the OTP shadow in mimxrt685_evk_init()
/Zephyr-latest/drivers/sensor/silabs/si7210/
Dsi7210.c119 * the register, but they get reloaded from OTP during wake-up. in si7210_sleep()
189 LOG_ERR("Failed to write OTP address register"); in si7210_otp_reg_read_byte()
195 LOG_ERR("Failed to write OTP control register"); in si7210_otp_reg_read_byte()
206 LOG_ERR("Failed to read OTP data register"); in si7210_otp_reg_read_byte()
/Zephyr-latest/drivers/sensor/nxp/nxp_tempmon/
Dnxp_tempmon.c13 /* OTP Controller Analog Register 1 for calibration values */
/Zephyr-latest/include/zephyr/drivers/wifi/nrf_wifi/off_raw_tx/
Doff_raw_tx_api.h179 * This address can be used to override the MAC addresses programmed in the OTP and
184 * - If none of the above are provided, the MAC address is set to the value programmed in the OTP.
/Zephyr-latest/dts/riscv/sifive/
Driscv32-fe310.dtsi135 otp: otp@10010000 { label
/Zephyr-latest/drivers/sensor/tdk/icp10125/
Dicp10125.c75 /* Request preparation for OTP data read. It should issue before data read request.
83 /* OTP data read request.
/Zephyr-latest/drivers/ieee802154/
Dieee802154_dw1000_regs.h1406 * On Wake-up load the EUI from OTP memory into Register file:
1504 /* 32-bit register. The data value to be programmed into an OTP location */
1507 /* 16-bit register used to select the address within the OTP memory block */
1511 * This 11-bit field specifies the address within OTP memory
1515 /* used to control the operation of the OTP memory */
1519 /* This bit forces the OTP into manual read mode */
1536 /* OTP Programming Done */
1538 /* OTP Programming Voltage OK */
1540 /* 32-bit register. The data value read from an OTP location will appear here */
1544 * 32-bit register. The data value stored in the OTP SR (0x400) location
/Zephyr-latest/boards/lowrisc/opentitan_earlgrey/doc/
Dindex.rst77 --meminit=otp,$OT_HOME/bazel-out/k8-fastbuild/bin/hw/ip/otp_ctrl/data/img_rma.24.vmem \
/Zephyr-latest/drivers/wifi/nrf_wifi/
DKconfig.nrfwifi504 This option overrides the MAC address read from OTP. It is strictly for testing purposes only.
514 bool "Use MAC address from OTP"
516 This option uses the MAC address stored in the OTP memory of the nRF70.
/Zephyr-latest/boards/st/sensortile_box/doc/
Dindex.rst164 …Found DFU: [0483:df11] ver=2200, devnum=74, cfg=1, intf=0, path="2-2", alt=2, name="@OTP Memory /0…
/Zephyr-latest/boards/waveshare/esp32s3_touch_lcd_1_28/doc/
Dindex.rst44 - 4-Kbit OTP, up to 1792 bits for users
/Zephyr-latest/drivers/wifi/nrf_wifi/off_raw_tx/src/
Doff_raw_tx_api.c236 LOG_ERR("%s: Fetching of MAC address from OTP failed", in nrf70_off_raw_tx_init()
/Zephyr-latest/drivers/crypto/
Dcrypto_smartbond.c312 /* Check whether the cipher key is located in OTP (user keys segment) */ in crypto_smartbond_cipher_key_load()
412 /* Peripherals should access the OTP memory through its peripheral address space. */ in crypto_smartbond_set_in_out_buf()
/Zephyr-latest/boards/st/stm32wb5mmg/doc/
Dstm32wb5mmg.rst122 - 1 Kbyte (128 double words) OTP

123