Searched full:d7 (Results 1 – 25 of 257) sorted by relevance
1234567891011
18 - VIN D7 NC40 Arduino UNO layout, labeled from D0 at the bottom to D7 at the top, but D641 and D7 are not connected.
19 22 MIPI_CSI_CLKP/D7 MIPI_CSI_DN1/D8 2120 24 MIPI_CSI_CLKN/D6 MIPI_CSI_CLKP/D7 23
17 signals labeled from D0 at the bottom D7 at the top;38 - VIN D7 13
28 6 D6 D7 7
28 busy-gpios = <&arduino_header 13 GPIO_ACTIVE_HIGH>; /* D7 */30 softstart = [d7 d6 9d];
28 busy-gpios = <&arduino_header 13 GPIO_ACTIVE_HIGH>; /* D7 */
28 busy-gpios = <&arduino_header 13 GPIO_ACTIVE_LOW>; /* D7 */
29 busy-gpios = <&arduino_header 13 GPIO_ACTIVE_LOW>; /* D7 */
11 timerout-gpios = <&gpioc 3 GPIO_ACTIVE_LOW>; /* Arduino D7 */
14 /* D7 */
21 /* D7 */
28 * Registers s0-s15 (d0-d7, q0-q3) do not have to be preserved (and can be used34 uint32_t s[16]; /* s0~s15 (d0-d7) */
15 reset-gpios = <&arduino_header 13 GPIO_ACTIVE_LOW>; /* D7 */
27 /* Syntax prefix LD_CUSTOM_CHAR [addr] [d0 …d7]31 * [D0...D7] 8 bytes Custom character pattern bit map
19 reset-gpios = <&arduino_header 13 GPIO_ACTIVE_LOW>; /* D7 */
16 irq-gpios = <&arduino_header 13 GPIO_ACTIVE_LOW>; /* D7 */
16 reset-gpios = <&arduino_header 13 GPIO_ACTIVE_HIGH>; /* D7 */
13 /* D7 */
7 <PA11MFP_I2C2_SCL>; /* UNO D7 */
27 device-wake-gpios = <&arduino_header 13 GPIO_ACTIVE_HIGH>; /* D7 */
20 <7 0 &gpio0 20 0>, /* D7 */
20 <7 0 &gpio0 17 0>, /* D7 */
