/Zephyr-Core-3.5.0/samples/sensor/accel_polling/ |
D | README.rst | 38 lis2dh@19 [m/s^2]: ( -6.013728, -3.064320, 7.277760) 39 lis2dh@19 [m/s^2]: ( -6.128640, -3.026016, 7.201152) 40 lis2dh@19 [m/s^2]: ( -6.090336, -3.064320, 7.162848) 41 lis2dh@19 [m/s^2]: ( -6.128640, -3.026016, 7.354368) 42 lis2dh@19 [m/s^2]: ( -6.166944, -3.102624, 7.277760) 43 lis2dh@19 [m/s^2]: ( -6.128640, -2.987712, 7.277760) 44 lis2dh@19 [m/s^2]: ( -6.052032, -2.987712, 7.277760) 45 lis2dh@19 [m/s^2]: ( -6.166944, -2.987712, 7.239456) 46 lis2dh@19 [m/s^2]: ( -6.090336, -3.026016, 7.201152)
|
/Zephyr-Core-3.5.0/samples/drivers/counter/maxim_ds3231/ |
D | README.rst | 29 week, and day of year (19 July 2019 is a Friday, and is the 200th day of 37 Now 1563512509: 2019-07-19 05:01:49 Fri 200 50 Set 2019-07-19 06:00:00.034000000 Fri 200 at 34 ms past: 0 74 Min Sec base time: 2019-07-19 06:00:07 Fri 200 75 Set sec alarm 90 at 1563516007 ~ 2019-07-19 06:00:07 Fri 200: 5 76 Set min alarm flags f at 1563516007 ~ 2019-07-19 06:00:07 Fri 200: 7 103 2019-07-19 06:01:00 Fri 200: adj 0.002000000, uptime 0:01:00.002, clk err 34 ppm 104 2019-07-19 06:02:00 Fri 200: adj 0.003000000, uptime 0:02:00.004, clk err 25 ppm 105 2019-07-19 06:03:00 Fri 200: adj 0.005000000, uptime 0:03:00.005, clk err 28 ppm 106 2019-07-19 06:04:00 Fri 200: adj 0.006000000, uptime 0:04:00.007, clk err 25 ppm [all …]
|
/Zephyr-Core-3.5.0/boards/arm/reel_board/ |
D | reel_board_v2-pinctrl.dtsi | 9 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 17 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>,
|
D | reel_board-pinctrl.dtsi | 9 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 17 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/samples/userspace/shared_mem/src/ |
D | main.h | 54 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, 25} 56 17, 18, 19, 20, 21, 22, 23, 24, 25, 5, 0, 4, 1, 3, 2} 58 15, 14, 17, 16, 19, 18, 21, 20, 23, 22, 25, 24}
|
/Zephyr-Core-3.5.0/boards/arm/stm32f411e_disco/ |
D | stm32f411e_disco_B.overlay | 16 /delete-node/ lsm303agr-accel@19; 24 lsm303dlhc_accel: lsm303dlhc-accel@19 {
|
/Zephyr-Core-3.5.0/boards/arm/nrf9160dk_nrf9160/dts/ |
D | nrf9160dk_uart1_on_if0_3.dtsi | 13 <NRF_PSEL(UART_CTS, 0, 19)>; 22 <NRF_PSEL(UART_CTS, 0, 19)>;
|
/Zephyr-Core-3.5.0/dts/bindings/sensor/ |
D | st,stm32-temp.yaml | 17 STM32F1 Table 5.3.19 (min 4 mV/C, max 4.6, default 4.3) 26 STM32F1 Table 5.3.19 (min 1340, max 1520, default 1430)
|
/Zephyr-Core-3.5.0/boards/arm/ubx_bmd380eval_nrf52840/ |
D | ubx_bmd380eval_nrf52840-pinctrl.dtsi | 91 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 99 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 108 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>, 119 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/tests/drivers/adc/adc_api/boards/ |
D | b_u585i_iot02a_adc4.overlay | 10 io-channels = <&adc4 18>, <&adc4 19>; 28 reg = <19>;
|
/Zephyr-Core-3.5.0/boards/arm/stm32f3_disco/ |
D | stm32f3_disco_E.overlay | 16 /delete-node/ lsm303dlhc-accel@19; 23 lsm303agr_accel: lsm303agr-accel@19 {
|
/Zephyr-Core-3.5.0/soc/x86/apollo_lake/ |
D | soc_gpio.h | 42 #define APL_GPIO_19 19 76 #define APL_GPIO_63 19 126 #define APL_GPIO_PMC_SPI_FS1 19 160 #define APL_GPIO_91 19 209 #define APL_GPIO_149 19 260 #define APL_GPIO_171 19
|
/Zephyr-Core-3.5.0/soc/riscv/riscv-ite/it8xxx2/ |
D | ilm.c | 61 /* Bits 16..18 and 19 of address, plus the enable bit for the entire SCAR; SCARnH */ 90 BUILD_ASSERT((FLASH_BASE & GENMASK(19, 0)) == 0, in it8xxx2_configure_ilm_block() 92 if (((uintptr_t)flash_addr - FLASH_BASE) & ~GENMASK(19, 0)) { in it8xxx2_configure_ilm_block() 116 if ((uintptr_t)flash_addr & BIT(19)) { in it8xxx2_configure_ilm_block() 193 SCAR_REG(19), SCAR_REG(19), SCAR_REG(19), SCAR_REG(19),
|
/Zephyr-Core-3.5.0/boards/arm/nrf52_adafruit_feather/ |
D | nrf52_adafruit_feather-pinctrl.dtsi | 40 <NRF_PSEL(PWM_OUT1, 0, 19)>; 47 <NRF_PSEL(PWM_OUT1, 0, 19)>;
|
/Zephyr-Core-3.5.0/dts/bindings/gpio/ |
D | particle-gen3-header.yaml | 19 16-pin header, skipping the bottom pin then assigning 9 through 19, 27 19 ADC0 LiPo+ -
|
/Zephyr-Core-3.5.0/boards/arm/actinius_icarus_som_dk/ |
D | arduino_connector.dtsi | 17 <4 0 &gpio0 19 0>, /* A4 */ 32 <19 0 &gpio0 3 0>, /* D13 */ 44 <4 &adc 6>, /* A4 = P0.19 = AIN6 */
|
/Zephyr-Core-3.5.0/samples/kernel/condition_variables/simple/ |
D | README.rst | 57 [thread 19] working (0/5) 77 [thread 19] working (1/5) 98 [thread 19] working (2/5) 118 [thread 19] working (3/5) 138 [thread 19] working (4/5) 193 [thread 18] done is now 19. Signalling cond. 195 [thread zephyr_app_main] done is 19 which is < 20 so waiting on cond 196 [thread 19] done is now 20. Signalling cond.
|
/Zephyr-Core-3.5.0/boards/arm/particle_argon/dts/ |
D | mesh_feather-pinctrl.dtsi | 24 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 32 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/boards/arm/particle_boron/dts/ |
D | mesh_feather-pinctrl.dtsi | 24 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 32 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/boards/arm/particle_xenon/dts/ |
D | mesh_feather-pinctrl.dtsi | 24 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 32 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/drivers/usb/device/ |
D | usb_dw_registers.h | 120 #define USB_DW_GINTSTS_OEP_INT BIT(19) 247 #define USB_DW_DEPTSIZ_PKT_CNT_OFFSET 19 248 #define USB_DW_DIEPTSIZ0_PKT_CNT_MASK (0x3 << 19) 249 #define USB_DW_DIEPTSIZn_PKT_CNT_MASK (0x3FF << 19) 250 #define USB_DW_DOEPTSIZn_PKT_CNT_MASK (0x3FF << 19) 251 #define USB_DW_DOEPTSIZ0_PKT_CNT_MASK (0x1 << 19)
|
/Zephyr-Core-3.5.0/boards/arm/ubx_bmd345eval_nrf52840/ |
D | ubx_bmd345eval_nrf52840-pinctrl.dtsi | 106 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 114 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 140 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>, 151 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/boards/arm/raytac_mdbt50q_db_40_nrf52840/ |
D | raytac_mdbt50q_db_40_nrf52840-pinctrl.dtsi | 131 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 139 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 148 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>, 159 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/boards/arm/ubx_bmd340eval_nrf52840/ |
D | ubx_bmd340eval_nrf52840-pinctrl.dtsi | 121 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 129 psels = <NRF_PSEL(SPIM_SCK, 0, 19)>, 138 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>, 149 psels = <NRF_PSEL(QSPI_SCK, 0, 19)>,
|
/Zephyr-Core-3.5.0/boards/arm/cc1352r1_launchxl/ |
D | boosterpack_connector.dtsi | 25 <19 0 &gpio0 3 0>, 35 <37 0 &gpio0 19 0>,
|