| /Zephyr-Core-3.6.0/drivers/ethernet/ |
| D | eth_xlnx_gem.c | 94 uint32_t reg_val; in DT_INST_FOREACH_STATUS_OKAY() local
269 uint32_t reg_val; in eth_xlnx_gem_isr() local
359 uint32_t reg_val; in eth_xlnx_gem_send() local
524 uint32_t reg_val; in eth_xlnx_gem_start_device() local
573 uint32_t reg_val; in eth_xlnx_gem_stop_device() local
851 uint32_t reg_val = 0; in eth_xlnx_gem_set_initial_nwcfg() local
972 uint32_t reg_val; in eth_xlnx_gem_set_nwcfg_link_speed() local
1041 uint32_t reg_val = 0; in eth_xlnx_gem_set_initial_dmacr() local
1373 uint32_t reg_val; in eth_xlnx_gem_handle_rx_pending() local
1552 uint32_t reg_val; in eth_xlnx_gem_handle_tx_done() local
|
| D | eth_dwmac_stm32h7x.c | 50 uint32_t reg_addr, reg_val; in dwmac_bus_init() local
|
| D | eth_dwmac.c | 461 uint32_t reg_val; in dwmac_set_mac_addr() local
474 uint32_t reg_val; in dwmac_set_config() local
515 uint32_t reg_val; in dwmac_iface_init() local
568 uint32_t reg_val; in dwmac_probe() local
|
| /Zephyr-Core-3.6.0/drivers/serial/ |
| D | uart_rcar.c | 134 uint8_t reg_val; in uart_rcar_set_baudrate() local
143 uint16_t reg_val; in uart_rcar_poll_in() local
169 uint16_t reg_val; in uart_rcar_poll_out() local
190 uint16_t reg_val; in uart_rcar_configure() local
324 uint16_t reg_val; in uart_rcar_fifo_fill() local
349 uint16_t reg_val; in uart_rcar_fifo_read() local
372 uint16_t reg_val; in uart_rcar_irq_tx_enable() local
386 uint16_t reg_val; in uart_rcar_irq_tx_disable() local
405 uint16_t reg_val; in uart_rcar_irq_rx_enable() local
419 uint16_t reg_val; in uart_rcar_irq_rx_disable() local
[all …]
|
| D | uart_renesas_ra.c | 216 uint8_t reg_val; in uart_ra_set_baudrate() local
255 uint8_t reg_val; in uart_ra_poll_out() local
281 uint8_t reg_val; in uart_ra_err_check() local
312 uint16_t reg_val; in uart_ra_configure() local
427 uint8_t reg_val; in uart_ra_fifo_fill() local
474 uint16_t reg_val; in uart_ra_irq_tx_enable() local
491 uint16_t reg_val; in uart_ra_irq_tx_disable() local
506 const uint8_t reg_val = uart_ra_read_8(dev, SSR); in uart_ra_irq_tx_ready() local
516 uint16_t reg_val; in uart_ra_irq_rx_enable() local
533 uint16_t reg_val; in uart_ra_irq_rx_disable() local
|
| D | uart_xlnx_ps.c | 182 uint32_t reg_val = sys_read32(reg_base + XUARTPS_CR_OFFSET); in xlnx_ps_disable_uart() local
206 uint32_t reg_val = sys_read32(reg_base + XUARTPS_CR_OFFSET); in xlnx_ps_enable_uart() local
285 uint32_t reg_val; in uart_xlnx_ps_init() local
346 uint32_t reg_val = sys_read32(reg_base + XUARTPS_SR_OFFSET); in uart_xlnx_ps_poll_in() local
373 uint32_t reg_val; in uart_xlnx_ps_poll_out() local
872 uint32_t reg_val = sys_read32(reg_base + XUARTPS_SR_OFFSET); in uart_xlnx_ps_fifo_read() local
923 uint32_t reg_val = sys_read32(reg_base + XUARTPS_SR_OFFSET); in uart_xlnx_ps_irq_tx_ready() local
942 uint32_t reg_val = sys_read32(reg_base + XUARTPS_SR_OFFSET); in uart_xlnx_ps_irq_tx_complete() local
985 uint32_t reg_val = sys_read32(reg_base + XUARTPS_ISR_OFFSET); in uart_xlnx_ps_irq_rx_ready() local
|
| /Zephyr-Core-3.6.0/include/zephyr/dt-bindings/adc/ |
| D | stm32h7_adc.h | 23 #define STM32H72X_ADC3_RES(resolution, reg_val) \ argument
|
| D | stm32_adc.h | 37 #define STM32_ADC(real_val, reg_val, mask, shift, reg) \ argument
63 #define STM32_ADC_RES(resolution, reg_val) \ argument
|
| /Zephyr-Core-3.6.0/drivers/sensor/bma4xx/ |
| D | bma4xx.c | 22 static int bma4xx_offset_to_reg_val(const struct sensor_value *val, uint8_t *reg_val) in bma4xx_offset_to_reg_val()
42 uint8_t reg_val[3]; in bma4xx_attr_set_offset() local
90 static int bma4xx_odr_to_reg(uint32_t microhertz, uint8_t *reg_val) in bma4xx_odr_to_reg()
116 uint8_t reg_val; in bma4xx_attr_set_odr() local
141 static int bma4xx_fs_to_reg(int32_t range_ug, uint8_t *reg_val) in bma4xx_fs_to_reg()
168 uint8_t reg_val; in bma4xx_attr_set_range() local
|
| /Zephyr-Core-3.6.0/arch/arm/core/cortex_a_r/ |
| D | prep_c.c | 91 uint32_t reg_val = 0; in z_arm_floating_point_init() local
|
| /Zephyr-Core-3.6.0/drivers/timer/ |
| D | rcar_cmt_timer.c | 64 uint32_t reg_val; in cmt_isr() local
95 uint32_t reg_val; in sys_clock_driver_init() local
|
| /Zephyr-Core-3.6.0/drivers/pinctrl/ |
| D | pinctrl_gd32_afio.c | 121 uint32_t port, pin_bit, reg_val; in configure_pin() local
186 uint32_t reg_val; in configure_remap() local
|
| D | pinctrl_smartbond.c | 28 uint32_t reg_val; in pinctrl_configure_pin() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/mpr/ |
| D | mpr.h | 32 uint32_t reg_val; member
|
| /Zephyr-Core-3.6.0/drivers/charger/ |
| D | sbs_charger.c | 71 uint16_t reg_val; in sbs_charger_charge_enable() local
86 uint16_t reg_val; in sbs_charger_get_prop() local
|
| /Zephyr-Core-3.6.0/arch/arm/core/ |
| D | gdbstub.c | 101 uint32_t reg_val; in arch_gdb_init() local
119 uint32_t reg_val = ctx.registers[PC]; in arch_gdb_step() local
|
| /Zephyr-Core-3.6.0/drivers/pwm/ |
| D | pwm_rcar.c | 78 uint32_t reg_val = pwm_rcar_read(config, offs); in pwm_rcar_write_bit() local
92 uint32_t reg_val, power, diviser; in pwm_rcar_update_clk() local
139 uint32_t reg_val; in pwm_rcar_set_cycles() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmc150_magn/ |
| D | bmc150_magn.c | 30 uint8_t reg_val; member
110 uint8_t reg_val; in bmc150_magn_read_rep_xy() local
126 uint8_t reg_val; in bmc150_magn_read_rep_z() local
172 uint8_t i, odr_val, reg_val; in bmc150_magn_read_odr() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/hp206c/ |
| D | hp206c.c | 49 uint8_t *reg_val) in hp206c_read_reg()
71 uint8_t reg_val) in hp206c_write_reg()
124 uint8_t reg_val; in hp206c_altitude_offs_set() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmi08x/ |
| D | bmi08x.c | 62 int32_t bmi08x_reg_val_to_range(uint8_t reg_val, const struct bmi08x_range *range_map, in bmi08x_reg_val_to_range()
|
| /Zephyr-Core-3.6.0/drivers/mdio/ |
| D | mdio_xmc4xxx.c | 31 uint8_t reg_val; member
126 uint8_t reg_val = mdio_clock_divider[i].reg_val; in mdio_xmc4xxx_set_clock_divider() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/lis2dh/ |
| D | lis2dh_trigger.c | 146 uint8_t reg_val; in lis2dh_trigger_anym_tap_set() local
300 uint8_t range_g, reg_val; in lis2dh_acc_slope_config() local
468 uint8_t reg_val = 0; in lis2dh_thread_cb() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmm150/ |
| D | bmm150.c | 17 uint8_t reg_val; member
121 uint8_t reg_val; in bmm150_read_rep_xy() local
136 uint8_t reg_val; in bmm150_read_rep_z() local
182 uint8_t i, odr_val, reg_val; in bmm150_read_odr() local
|
| /Zephyr-Core-3.6.0/drivers/regulator/ |
| D | regulator_da1469x.c | 173 uint32_t reg_val; in regulator_da1469x_enable() local
207 uint32_t reg_val; in regulator_da1469x_disable() local
304 uint32_t reg_val; in regulator_da1469x_set_current_limit() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmi160/ |
| D | bmi160.c | 332 static int32_t bmi160_reg_val_to_range(uint8_t reg_val, in bmi160_reg_val_to_range()
347 int32_t bmi160_acc_reg_val_to_range(uint8_t reg_val) in bmi160_acc_reg_val_to_range()
353 int32_t bmi160_gyr_reg_val_to_range(uint8_t reg_val) in bmi160_gyr_reg_val_to_range()
379 int32_t reg_val = bmi160_range_to_reg_val(range_g, in bmi160_acc_range_set() local
427 int32_t reg_val; in bmi160_acc_ofs_set() local
461 uint8_t reg_val = 0U; in bmi160_acc_calibrate() local
560 int32_t reg_val = bmi160_range_to_reg_val(range, in bmi160_gyr_range_set() local
|
