| /Zephyr-Core-3.6.0/drivers/serial/ |
| D | uart_msp432p4xx.c | 228 unsigned int int_status; in uart_msp432p4xx_irq_tx_ready() local
261 unsigned int int_status; in uart_msp432p4xx_irq_rx_ready() local
282 unsigned int int_status; in uart_msp432p4xx_irq_is_pending() local
315 unsigned int int_status; in uart_msp432p4xx_isr() local
|
| D | uart_cc32xx.c | 189 unsigned int int_status; in uart_cc32xx_irq_tx_ready() local
221 unsigned int int_status; in uart_cc32xx_irq_rx_ready() local
241 unsigned int int_status; in uart_cc32xx_irq_is_pending() local
|
| /Zephyr-Core-3.6.0/drivers/i2c/ |
| D | i2c_xilinx_axi.c | 54 uint32_t int_status; in i2c_xilinx_axi_target_register() local
133 struct i2c_xilinx_axi_data *data, uint32_t int_status, in i2c_xilinx_axi_target_isr()
224 const uint32_t int_status = sys_read32(config->base + REG_ISR) & int_enable; in i2c_xilinx_axi_isr() local
297 const uint32_t int_status = sys_read32(config->base + REG_ISR); in i2c_xilinx_axi_clear_interrupt() local
|
| D | i2c_cc32xx.c | 268 uint32_t int_status; in i2c_cc32xx_isr() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/icm42688/ |
| D | icm42688_decoder.h | 23 uint8_t int_status; member
|
| D | icm42688.h | 415 uint8_t int_status; member
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmp581/ |
| D | bmp581.c | 187 static int get_interrupt_status(uint8_t *int_status, const struct device *dev) in get_interrupt_status()
330 uint8_t int_status = 0; in soft_reset() local
|
| /Zephyr-Core-3.6.0/drivers/gpio/ |
| D | gpio_ambiq.c | 231 uint32_t int_status; in ambiq_gpio_isr() local
247 uint32_t int_status; in ambiq_gpio_pin_interrupt_configure() local
|
| D | gpio_xlnx_ps_bank.c | 362 uint32_t int_status; in gpio_xlnx_ps_bank_get_int_status() local
|
| D | gpio_cc32xx.c | 220 uint32_t int_status; in gpio_cc32xx_port_isr() local
|
| D | gpio_imx.c | 233 uint32_t int_status; in imx_gpio_port_isr() local
|
| D | gpio_numicro.c | 228 uint32_t int_status; in gpio_numicro_isr() local
|
| D | gpio_numaker.c | 232 uint32_t int_status; in gpio_numaker_isr() local
|
| D | gpio_rv32m1.c | 258 uint32_t int_status; in gpio_rv32m1_port_isr() local
|
| D | gpio_mcux.c | 259 uint32_t int_status; in gpio_mcux_port_isr() local
|
| D | gpio_gecko.c | 338 uint32_t enabled_int, int_status; in gpio_gecko_common_isr() local
|
| D | gpio_litex.c | 198 uint8_t int_status = in gpio_litex_irq_handler() local
|
| D | gpio_dw.c | 391 uint32_t int_status; in gpio_dw_isr() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmi270/ |
| D | bmi270_trigger.c | 55 uint16_t int_status; in bmi270_thread_cb() local
|
| /Zephyr-Core-3.6.0/drivers/sensor/bmi160/ |
| D | bmi160_trigger.c | 49 uint8_t int_status[4]; in bmi160_handle_interrupts() member
|
| /Zephyr-Core-3.6.0/drivers/spi/ |
| D | spi_dw.c | 499 uint32_t int_status; in spi_dw_isr() local
|
| /Zephyr-Core-3.6.0/drivers/virtualization/ |
| D | virt_ivshmem.h | 69 uint32_t int_status; member
|
| /Zephyr-Core-3.6.0/drivers/ethernet/ |
| D | eth_smsc911x.c | 599 uint32_t int_status = SMSC9220->INT_STS; in eth_smsc911x_isr() local
|
| /Zephyr-Core-3.6.0/drivers/pwm/ |
| D | pwm_numaker.c | 356 uint32_t int_status; in pwm_numaker_isr() local
|
| /Zephyr-Core-3.6.0/drivers/counter/ |
| D | counter_andes_atcpit100.c | 89 uint32_t int_status, int_enable, ch_enable, cur_ticks; in atcpit100_irq_handler() local
|
