1 /***************************************************************************//** 2 * @file 3 * @brief DEVICE_INIT_LFRCO Config 4 ******************************************************************************* 5 * # License 6 * <b>Copyright 2022 Silicon Laboratories Inc. www.silabs.com</b> 7 ******************************************************************************* 8 * 9 * SPDX-License-Identifier: Zlib 10 * 11 * The licensor of this software is Silicon Laboratories Inc. 12 * 13 * This software is provided 'as-is', without any express or implied 14 * warranty. In no event will the authors be held liable for any damages 15 * arising from the use of this software. 16 * 17 * Permission is granted to anyone to use this software for any purpose, 18 * including commercial applications, and to alter it and redistribute it 19 * freely, subject to the following restrictions: 20 * 21 * 1. The origin of this software must not be misrepresented; you must not 22 * claim that you wrote the original software. If you use this software 23 * in a product, an acknowledgment in the product documentation would be 24 * appreciated but is not required. 25 * 2. Altered source versions must be plainly marked as such, and must not be 26 * misrepresented as being the original software. 27 * 3. This notice may not be removed or altered from any source distribution. 28 * 29 ******************************************************************************/ 30 31 #ifndef SL_DEVICE_INIT_LFRCO_CONFIG_H 32 #define SL_DEVICE_INIT_LFRCO_CONFIG_H 33 34 // <<< Use Configuration Wizard in Context Menu >>> 35 36 // <o SL_DEVICE_INIT_LFRCO_PRECISION> Precision Mode 37 // <i> Precision mode uses hardware to automatically re-calibrate the LFRCO 38 // <i> against a crystal driven by the HFXO. Hardware detects temperature 39 // <i> changes and initiates a re-calibration of the LFRCO as needed when 40 // <i> operating in EM0, EM1, or EM2. If a re-calibration is necessary and the 41 // <i> HFXO is not active, the precision mode hardware will automatically 42 // <i> enable HFXO for a short time to perform the calibration. EM4 operation is 43 // <i> not allowed while precision mode is enabled. 44 // <i> If high precision is selected on devices that do not support it, default 45 // <i> precision will be used. 46 // <cmuPrecisionDefault=> Default precision 47 // <cmuPrecisionHigh=> High precision 48 // <i> Default: cmuPrecisionHigh 49 #define SL_DEVICE_INIT_LFRCO_PRECISION cmuPrecisionHigh 50 51 // <<< end of configuration section >>> 52 53 #endif // SL_DEVICE_INIT_LFRCO_CONFIG_H 54
