/* * Copyright (c) 2019-2022 Arm Limited. All rights reserved. * Copyright (c) 2020 Cypress Semiconductor Corporation. All rights reserved. * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #ifndef __FLASH_LAYOUT_H__ #define __FLASH_LAYOUT_H__ /* Use the QSPI as boot flash * * QSPI MPC BLK_CFG register value is 0xD. * Thus QSPI MPC Block size is 256 KB = 2 ^ (0xD + 5). */ /* The addresses used in the following layout are all NS alias * Flash layout on MPS3 AN524 with BL2 (single image boot): * * 0x0000_0000 BL2 - MCUBoot (256 KB) * Primary image area: * 0x0004_0000 Secure image (512 KB) * 0x000C_0000 Non-secure image (256 KB) * Secondary image area: * 0x0010_0000 Secure image (512 KB) * 0x0018_0000 Non-secure image (256 KB) * 0x001C_0000 PS area (20 KB) * 0x001C_5000 ITS area (16 KB) * 0x001C_9000 OTP / NV counters area (8 KB) * 0x001C_B000 Unused * * Flash layout without BL2 * * 0x0000_0000 Secure image (512 KB) * 0x000C_0000 Non-secure image (256 KB) * 0x001C_0000 PS area (20 KB) * 0x001C_5000 ITS area (16 KB) * 0x001C_9000 OTP / NV counters area (8 KB) * 0x001C_B000 Unused */ /* Size of a Secure and of a Non-secure image */ #define FLASH_S_PARTITION_SIZE (0x80000) /* S partition: 512 KB */ #define FLASH_NS_PARTITION_SIZE (0x40000) /* NS partition: 256 KB */ #if (FLASH_S_PARTITION_SIZE > FLASH_NS_PARTITION_SIZE) #define FLASH_MAX_PARTITION_SIZE FLASH_S_PARTITION_SIZE #else #define FLASH_MAX_PARTITION_SIZE FLASH_NS_PARTITION_SIZE #endif /* Sector size of the flash hardware; same as FLASH0_SECTOR_SIZE */ #define FLASH_AREA_IMAGE_SECTOR_SIZE (0x1000) /* 4 KB */ /* Same as FLASH0_SIZE */ #define FLASH_TOTAL_SIZE (0x800000) /* 8 MB */ /* Flash base info for BL2 bootloader */ #define FLASH_BASE_ADDRESS (0x10000000) /* Offset to QSPI base */ #define FLASH_AREA_BL2_OFFSET (0x0) #define FLASH_AREA_BL2_SIZE (0x40000) /* 256 KB */ #if !defined(MCUBOOT_IMAGE_NUMBER) || (MCUBOOT_IMAGE_NUMBER == 1) /* Secure + Non-secure image primary slot */ #define FLASH_AREA_0_ID (1) #define FLASH_AREA_0_OFFSET (FLASH_AREA_BL2_OFFSET + FLASH_AREA_BL2_SIZE) #define FLASH_AREA_0_SIZE (FLASH_S_PARTITION_SIZE + \ FLASH_NS_PARTITION_SIZE) /* Secure + Non-secure secondary slot */ #define FLASH_AREA_2_ID (FLASH_AREA_0_ID + 1) #define FLASH_AREA_2_OFFSET (FLASH_AREA_0_OFFSET + FLASH_AREA_0_SIZE) #define FLASH_AREA_2_SIZE (FLASH_S_PARTITION_SIZE + \ FLASH_NS_PARTITION_SIZE) /* Not used, only the Non-swapping firmware upgrade operation * is supported on AN524. */ #define FLASH_AREA_SCRATCH_ID (FLASH_AREA_2_ID + 1) #define FLASH_AREA_SCRATCH_OFFSET (FLASH_AREA_2_OFFSET + FLASH_AREA_2_SIZE) #define FLASH_AREA_SCRATCH_SIZE (0) /* Maximum number of image sectors supported by the bootloader. */ #define MCUBOOT_MAX_IMG_SECTORS ((FLASH_S_PARTITION_SIZE + \ FLASH_NS_PARTITION_SIZE) / \ FLASH_AREA_IMAGE_SECTOR_SIZE) #elif (MCUBOOT_IMAGE_NUMBER == 2) /* Secure image primary slot */ #define FLASH_AREA_0_ID (1) #define FLASH_AREA_0_OFFSET (FLASH_AREA_BL2_OFFSET + FLASH_AREA_BL2_SIZE) #define FLASH_AREA_0_SIZE (FLASH_S_PARTITION_SIZE) /* Non-secure image primary slot */ #define FLASH_AREA_1_ID (FLASH_AREA_0_ID + 1) #define FLASH_AREA_1_OFFSET (FLASH_AREA_0_OFFSET + FLASH_AREA_0_SIZE) #define FLASH_AREA_1_SIZE (FLASH_NS_PARTITION_SIZE) /* Secure image secondary slot */ #define FLASH_AREA_2_ID (FLASH_AREA_1_ID + 1) #define FLASH_AREA_2_OFFSET (FLASH_AREA_1_OFFSET + FLASH_AREA_1_SIZE) #define FLASH_AREA_2_SIZE (FLASH_S_PARTITION_SIZE) /* Non-secure image secondary slot */ #define FLASH_AREA_3_ID (FLASH_AREA_2_ID + 1) #define FLASH_AREA_3_OFFSET (FLASH_AREA_2_OFFSET + FLASH_AREA_2_SIZE) #define FLASH_AREA_3_SIZE (FLASH_NS_PARTITION_SIZE) /* Not used, only the Non-swapping firmware upgrade operation * is supported on AN524. */ #define FLASH_AREA_SCRATCH_ID (FLASH_AREA_3_ID + 1) #define FLASH_AREA_SCRATCH_OFFSET (FLASH_AREA_3_OFFSET + FLASH_AREA_3_SIZE) #define FLASH_AREA_SCRATCH_SIZE (0) /* Maximum number of image sectors supported by the bootloader. */ #define MCUBOOT_MAX_IMG_SECTORS (FLASH_MAX_PARTITION_SIZE / \ FLASH_AREA_IMAGE_SECTOR_SIZE) #else /* MCUBOOT_IMAGE_NUMBER > 2 */ #error "Only MCUBOOT_IMAGE_NUMBER 1 and 2 are supported!" #endif /* MCUBOOT_IMAGE_NUMBER */ /* Not used, only the Non-swapping firmware upgrade operation * is supported on AN524. The maximum number of status entries * supported by the bootloader. */ #define MCUBOOT_STATUS_MAX_ENTRIES (0) /* Protected Storage (PS) Service definitions */ #define FLASH_PS_AREA_OFFSET (FLASH_AREA_SCRATCH_OFFSET + \ FLASH_AREA_SCRATCH_SIZE) #define FLASH_PS_AREA_SIZE (0x5000) /* 20 KB */ /* Internal Trusted Storage (ITS) Service definitions */ #define FLASH_ITS_AREA_OFFSET (FLASH_PS_AREA_OFFSET + \ FLASH_PS_AREA_SIZE) #define FLASH_ITS_AREA_SIZE (0x4000) /* 16 KB */ /* OTP_definitions */ #define FLASH_OTP_NV_COUNTERS_AREA_OFFSET (FLASH_ITS_AREA_OFFSET + \ FLASH_ITS_AREA_SIZE) #define FLASH_OTP_NV_COUNTERS_AREA_SIZE (FLASH_AREA_IMAGE_SECTOR_SIZE * 2) #define FLASH_OTP_NV_COUNTERS_SECTOR_SIZE FLASH_AREA_IMAGE_SECTOR_SIZE /* Offset and size definition in flash area used by assemble.py */ #define SECURE_IMAGE_OFFSET (0x0) #define SECURE_IMAGE_MAX_SIZE FLASH_S_PARTITION_SIZE #define NON_SECURE_IMAGE_OFFSET (SECURE_IMAGE_OFFSET + \ SECURE_IMAGE_MAX_SIZE) #define NON_SECURE_IMAGE_MAX_SIZE FLASH_NS_PARTITION_SIZE /* Flash device name used by BL2 * Name is defined in flash driver file: Driver_Flash.c */ #define FLASH_DEV_NAME Driver_FLASH0 /* Smallest flash programmable unit in bytes */ #define TFM_HAL_FLASH_PROGRAM_UNIT (0x4) /* Protected Storage (PS) Service definitions * Note: Further documentation of these definitions can be found in the * TF-M PS Integration Guide. */ #define TFM_HAL_PS_FLASH_DRIVER Driver_FLASH0 /* In this target the CMSIS driver requires only the offset from the base * address instead of the full memory address. */ /* Base address of dedicated flash area for PS */ #define TFM_HAL_PS_FLASH_AREA_ADDR FLASH_PS_AREA_OFFSET /* Size of dedicated flash area for PS */ #define TFM_HAL_PS_FLASH_AREA_SIZE FLASH_PS_AREA_SIZE #define PS_RAM_FS_SIZE TFM_HAL_PS_FLASH_AREA_SIZE /* Number of physical erase sectors per logical FS block */ #define TFM_HAL_PS_SECTORS_PER_BLOCK (1) /* Smallest flash programmable unit in bytes */ #define TFM_HAL_PS_PROGRAM_UNIT (0x1) /* Internal Trusted Storage (ITS) Service definitions * Note: Further documentation of these definitions can be found in the * TF-M ITS Integration Guide. The ITS should be in the internal flash, but is * allocated in the external flash just for development platforms that don't * have internal flash available. */ #define TFM_HAL_ITS_FLASH_DRIVER Driver_FLASH0 /* In this target the CMSIS driver requires only the offset from the base * address instead of the full memory address. */ /* Base address of dedicated flash area for ITS */ #define TFM_HAL_ITS_FLASH_AREA_ADDR FLASH_ITS_AREA_OFFSET /* Size of dedicated flash area for ITS */ #define TFM_HAL_ITS_FLASH_AREA_SIZE FLASH_ITS_AREA_SIZE #define ITS_RAM_FS_SIZE TFM_HAL_ITS_FLASH_AREA_SIZE /* Number of physical erase sectors per logical FS block */ #define TFM_HAL_ITS_SECTORS_PER_BLOCK (1) /* Smallest flash programmable unit in bytes */ #define TFM_HAL_ITS_PROGRAM_UNIT (0x1) /* OTP / NV counter definitions */ #define TFM_OTP_NV_COUNTERS_AREA_SIZE (FLASH_OTP_NV_COUNTERS_AREA_SIZE / 2) #define TFM_OTP_NV_COUNTERS_AREA_ADDR FLASH_OTP_NV_COUNTERS_AREA_OFFSET #define TFM_OTP_NV_COUNTERS_SECTOR_SIZE FLASH_OTP_NV_COUNTERS_SECTOR_SIZE #define TFM_OTP_NV_COUNTERS_BACKUP_AREA_ADDR (TFM_OTP_NV_COUNTERS_AREA_ADDR + \ TFM_OTP_NV_COUNTERS_AREA_SIZE) /* Use Internal SRAM0~3 to store RW data * ISRAM0 and ISRAM1 for Secure Data * ISRAM2 and ISRAM3 for Non-Secure Data */ #define S_ROM_ALIAS_BASE (0x10000000) #define NS_ROM_ALIAS_BASE (0x00000000) #define S_RAM_ALIAS_BASE (0x30000000) #define NS_RAM_ALIAS_BASE (0x20000000) #define TOTAL_RAM_SIZE (0x20000) /* 128 KB */ #endif /* __FLASH_LAYOUT_H__ */