#
# Copyright (c) 2020 Nordic Semiconductor ASA
#
# SPDX-License-Identifier: Apache-2.0
#

menuconfig STREAM_FLASH
	bool "Stream to flash"
	help
	  Enable support of stream to flash API

if STREAM_FLASH

config STREAM_FLASH_INSPECT
	bool "Check whether device layout is OK with Stream Flash definition"
	default y
	select FLASH_PAGE_LAYOUT
	help
	  Runs simple check to find whether provided device can be used for
	  stream flash by verifying that buffer size will fit into page.
	  Once correct configuration has been established and tested it is
	  worth to disable the option to cut out some unneeded code.

config STREAM_FLASH_POST_WRITE_CALLBACK
	bool "Write complete callback"
	default y
	help
	  Enable callback that will be invoked once data is synchronized from
	  stream to device. When callback is not used, disabling the option
	  allows to save some code storage and RAM.

config STREAM_FLASH_ERASE
	bool "Perform erase operations"
	depends on FLASH_HAS_EXPLICIT_ERASE
	help
	  If disabled an external actor must erase the flash area being written
	  to.
	  Option available only if there is at least one device in, a configuration,
	  that requires erase prior to write.

config STREAM_FLASH_ERASE_ONLY_WHEN_SUPPORTED
	bool "Check if device supports erase prior to attempting one"
	depends on STREAM_FLASH_ERASE
	depends on FLASH_HAS_NO_EXPLICIT_ERASE
	help
	  This is used in stream flash code to exclude invocation of erase on devices that do not
	  have such requirement prior to write nor support rase as a way to increase write speed.
	  Option is available only if there is a mix of devices, in a configuration, where some
	  support erase and some do not. If user is sure to not use Stream Flash with devices that
	  have no support for erase, this option may be disabled to discard small amount of code
	  from final application.

config STREAM_FLASH_PROGRESS
	bool "Persistent stream write progress"
	depends on SETTINGS
	depends on !SETTINGS_NONE
	help
	  Enable API for loading and storing the current write progress to flash
	  using the settings subsystem. In case of power failure or device
	  reset, the API can be used to resume writing from the latest state.

module = STREAM_FLASH
module-str = stream flash
source "subsys/logging/Kconfig.template.log_config"

endif # STREAM_FLASH