# Microchip MEC172X MCU core series # Copyright (c) 2021 Microchip Technology Inc. # SPDX-License-Identifier: Apache-2.0 config SOC_SERIES_MEC172X select ARM select CPU_CORTEX_M4 select CPU_CORTEX_M_HAS_DWT select CPU_HAS_FPU select CPU_HAS_ARM_MPU select HAS_SWO select HAS_PM select SOC_EARLY_INIT_HOOK if SOC_SERIES_MEC172X config RTOS_TIMER bool "MEC172x RTOS Timer(32KHz) as kernel timer" choice prompt "MEC172x debug interface general configuration" default SOC_MEC172X_DEBUG_WITHOUT_TRACING depends on SOC_SERIES_MEC172X help Select Debug SoC interface support for MEC172X SoC family config SOC_MEC172X_DEBUG_DISABLED bool "Disable debug support" help Debug port is disabled, JTAG/SWD cannot be enabled. JTAG_RST# pin is ignored. All other JTAG pins can be used as GPIOs or other non-JTAG alternate functions. config SOC_MEC172X_DEBUG_WITHOUT_TRACING bool "Debug support via Serial wire debug" help JTAG port in SWD mode. I2C09 and ADC00-03 can be used. config SOC_MEC172X_DEBUG_AND_TRACING bool "Debug support via Serial wire debug with tracing enabled" help JTAG port is enabled in SWD mode. Refer to tracing options to see if ADC00-03 can be used or not. endchoice choice prompt "MEC172X debug interface trace configuration" default SOC_MEC172X_DEBUG_AND_ETM_TRACING depends on SOC_MEC172X_DEBUG_AND_TRACING help Select tracing mode for debug interface config SOC_MEC172X_DEBUG_AND_ETM_TRACING bool "Debug support via Serial wire debug" help JTAG port in SWD mode and ETM as tracing method. I2C09 can be used, but ADC00-03 cannot. config SOC_MEC172X_DEBUG_AND_SWV_TRACING bool "debug support via Serial Wire Debug and Viewer" help JTAG port in SWD mode and SWV as tracing method. I2C09 cannot be used. ADC00-03 can be used. endchoice # GPIO initialization depends on ECIA initialization, which happen at # CONFIG_KERNEL_INIT_PRIORITY_DEFAULT, so GPIO_INIT_PRIORITY needs to be # higher than that. if GPIO config GPIO_INIT_PRIORITY default 41 endif # GPIO endif # SOC_SERIES_MEC172X