# Copyright (c) 2021 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

description: |
    When setting the odr and power-mode properties in a .dts or .dtsi file you may include
    lis2ds12.h and use the macros defined there.

    Example:
    #include <zephyr/dt-bindings/sensor/lis2ds12.h>

    lis2ds12: lis2ds12@0 {
      ...

      power-mode = <LIS2DS12_DT_LOW_POWER>;
      odr = <LIS2DS12_DT_ODR_12Hz5>;
    };

include: sensor-device.yaml

properties:
  irq-gpios:
    type: phandle-array
    description: |
      DRDY pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  range:
    type: int
    default: 2
    description: |
      Range in g. Default is power-up configuration.

      - 16 # 16g (0.488 mg/LSB)
      - 8  #  8g (0.244 mg/LSB)
      - 4  #  4g (0.122 mg/LSB)
      - 2  #  2g (0.061 mg/LSB)

    enum: [16, 8, 4, 2]

  power-mode:
    type: int
    default: 0
    description: |
      Specify the sensor power mode. Default is power-down mode

      - 0 # LIS2DS12_DT_POWER_DOWN
      - 1 # LIS2DS12_DT_LOW_POWER
      - 2 # LIS2DS12_DT_HIGH_RESOLUTION
      - 3 # LIS2DS12_DT_HIGH_FREQUENCY

    enum: [0, 1, 2, 3]

  odr:
    type: int
    default: 0
    description: |
        Specify the default output data rate expressed in samples per second (Hz).
        Default is power-down mode

        - 0  # LIS2DS12_DT_ODR_OFF
        - 1  # LIS2DS12_DT_ODR_1Hz_LP
        - 2  # LIS2DS12_DT_ODR_12Hz5
        - 3  # LIS2DS12_DT_ODR_25Hz
        - 4  # LIS2DS12_DT_ODR_50Hz
        - 5  # LIS2DS12_DT_ODR_100Hz
        - 6  # LIS2DS12_DT_ODR_200Hz
        - 7  # LIS2DS12_DT_ODR_400Hz
        - 8  # LIS2DS12_DT_ODR_800Hz
        - 9  # LIS2DS12_DT_ODR_1600Hz
        - 10 # LIS2DS12_DT_ODR_3200Hz_HF
        - 11 # LIS2DS12_DT_ODR_6400Hz_HF

    enum: [0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11]