# Copyright (c) 2024 STMicroelectronics
# SPDX-License-Identifier: Apache-2.0

description: |
    When setting the accel-range, accel-odr, properties in a .dts or .dtsi
    file you may include lis2de12.h and use the macros defined there.

    Example:
    #include <zephyr/dt-bindings/sensor/lis2de12.h>

    lis2de12: lis2de12@0 {
      ...

      accel-range = <LIS2DE12_DT_FS_16G>;
      accel-odr = <LIS2DE12_DT_ODR_AT_100Hz>;
    };

include: sensor-device.yaml

properties:
  int1-gpios:
    type: phandle-array
    description: |
      INT1 pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  int2-gpios:
    type: phandle-array
    description: |
      INT2 pin

      This pin defaults to active high when produced by the sensor.
      The property value should ensure the flags properly describe
      the signal that is presented to the driver.

  accel-range:
    type: int
    default: 0
    description: |
      Range in g. Default is power-up configuration.

      0 # LIS2DE12_DT_FS_2G  (15.6 mg/LSB)
      1 # LIS2DE12_DT_FS_4G  (31.2 mg/LSB)
      2 # LIS2DE12_DT_FS_8G  (62.5 mg/LSB)
      3 # LIS2DE12_DT_FS_16G (187.5 mg/LSB)

    enum: [0, 1, 2, 3]

  accel-odr:
    type: int
    default: 0x0
    description: |
      Specify the default accelerometer output data rate expressed in samples per second (Hz).
      The values are taken in accordance to lis2de12_md_t enumerative in hal/st
      module. Please note that this values will also enable/disable High performance mode.
      Default is power-up configuration.

      0x00 # LIS2DE12_DT_ODR_OFF
      0x01 # LIS2DE12_DT_ODR_AT_1Hz
      0x02 # LIS2DE12_DT_ODR_AT_10Hz
      0x03 # LIS2DE12_DT_ODR_AT_25Hz
      0x04 # LIS2DE12_DT_ODR_AT_50Hz
      0x05 # LIS2DE12_DT_ODR_AT_100Hz
      0x06 # LIS2DE12_DT_ODR_AT_200Hz
      0x07 # LIS2DE12_DT_ODR_AT_400Hz
      0x08 # LIS2DE12_DT_ODR_AT_1kHz620
      0x09 # LIS2DE12_DT_ODR_AT_5kHz376

    enum: [0x00, 0x01, 0x02, 0x03, 0x04, 0x05, 0x06, 0x07, 0x08, 0x09]

  drdy-pulsed:
    type: boolean
    description: |
      Selects the pulsed mode for data-ready interrupt when enabled,
      and the latched mode when disabled.