# # Copyright 2023-2024 NXP # # SPDX-License-Identifier: Apache-2.0 # config HCI_NXP_ENABLE_AUTO_SLEEP bool "BLE Controller auto sleep mode" help If enabled, the Controller auto sleep mode will be configured and enabled during HCI init. Auto sleep mode means the Controller will handle its low power state automatically. Enabling this feature will allow to save power at the cost of some latency when sending a HCI message to the Controller as the Host will need to wake it up. config HCI_NXP_SET_CAL_DATA bool "BLE Controller calibration data" help If enabled, the Host will send calibration data to the BLE Controller during HCI init. config HCI_NXP_SET_CAL_DATA_ANNEX100 bool "BLE Controller calibration data annex 100" help If enabled, the Host will send calibration data annex 100 to the BLE Controller during HCI init. config HCI_NXP_RX_THREAD bool "Process RX buffers in a dedicated thread" help Some platforms receive the HCI RX buffers in ISR context. If enabled, the HCI RX message is queued by the ISR, and the message is processed in a dedicated thread. if HCI_NXP_RX_THREAD config HCI_NXP_RX_STACK_SIZE int "HCI RX stack size" default 512 config HCI_NXP_RX_MSG_QUEUE_SIZE int "HCI RX message queue size" default 4 config HEAP_MEM_POOL_ADD_SIZE_BT_NXP_RX_THREAD int default 768 endif if BT_NXP config BT_DIS_MANUF default "NXP" config BT_HCI_ACL_FLOW_CONTROL default n config BT_BUF_EVT_DISCARDABLE_SIZE default 84 config HEAP_MEM_POOL_ADD_SIZE_BT_NXP int default 256 config FLASH default y endif # BT_NXP if BT_H4_NXP_CTLR config BT_NXP_NW612 bool "NXP IW612 Chipset" help NXP IW612 Chipset supports Wi-Fi? 802.11a/b/g/n/ac/ax + Bluetooth? 5.3 BR/EDR/LE + IEEE802.1.5.4 up to 601 Mbps data rate on Wi-Fi? and 2Mbps data rate on Bluetooth?. 4-wire UART@3M baud is supported. PCM for audio is also supported. Details of the module could be fond on https://www.nxp.com/products/ wireless-connectivity/wi-fi-plus-bluetooth-plus-802-15-4/2-4-5-ghz- dual-band-1x1-wi-fi-6-802-11ax-plus-bluetooth-5-4-plus-802-15-4-tri- radio-solution:IW612. endif # BT_H4_NXP_CTLR