/* * Copyright (c) 2022, NXP * * SPDX-License-Identifier: Apache-2.0 */ #ifndef ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_ #define ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_ #include #include #include "fsl_common.h" #ifdef __cplusplus extern "C" { #endif #define MCUX_IMX_INPUT_SCHMITT_ENABLE_SHIFT IOMUXC_SW_PAD_CTL_PAD_HYS_SHIFT #define MCUX_IMX_BIAS_PULL_DOWN_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUS_SHIFT #define MCUX_IMX_BIAS_PULL_UP_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUS_SHIFT #define MCUX_IMX_BIAS_BUS_HOLD_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUE_SHIFT #define MCUX_IMX_PULL_ENABLE_SHIFT IOMUXC_SW_PAD_CTL_PAD_PKE_SHIFT #define MCUX_IMX_DRIVE_OPEN_DRAIN_SHIFT IOMUXC_SW_PAD_CTL_PAD_ODE_SHIFT #define MCUX_IMX_SPEED_SHIFT IOMUXC_SW_PAD_CTL_PAD_SPEED_SHIFT #define MCUX_IMX_DRIVE_STRENGTH_SHIFT IOMUXC_SW_PAD_CTL_PAD_DSE_SHIFT #define MCUX_IMX_SLEW_RATE_SHIFT IOMUXC_SW_PAD_CTL_PAD_SRE_SHIFT #define MCUX_IMX_INPUT_ENABLE_SHIFT 31 /* Shift to a bit not used by IOMUXC_SW_PAD_CTL */ #define MCUX_IMX_INPUT_ENABLE(x) ((x >> MCUX_IMX_INPUT_ENABLE_SHIFT) & 0x1) #define Z_PINCTRL_MCUX_IMX_PINCFG_INIT(node_id) \ ((DT_PROP(node_id, input_schmitt_enable) << MCUX_IMX_INPUT_SCHMITT_ENABLE_SHIFT) | \ IF_ENABLED(DT_PROP(node_id, bias_pull_up), (DT_ENUM_IDX(node_id, bias_pull_up_value) \ << MCUX_IMX_BIAS_PULL_UP_SHIFT) |) \ IF_ENABLED(DT_PROP(node_id, bias_pull_down), (DT_ENUM_IDX(node_id, bias_pull_down_value)\ << MCUX_IMX_BIAS_PULL_DOWN_SHIFT) |) \ ((DT_PROP(node_id, bias_pull_down) | DT_PROP(node_id, bias_pull_up)) \ << MCUX_IMX_BIAS_BUS_HOLD_SHIFT) | \ ((!DT_PROP(node_id, bias_disable)) << MCUX_IMX_PULL_ENABLE_SHIFT) | \ (DT_PROP(node_id, drive_open_drain) << MCUX_IMX_DRIVE_OPEN_DRAIN_SHIFT) | \ (DT_ENUM_IDX(node_id, nxp_speed) << MCUX_IMX_SPEED_SHIFT) | \ (DT_ENUM_IDX(node_id, drive_strength) << MCUX_IMX_DRIVE_STRENGTH_SHIFT) | \ (DT_ENUM_IDX(node_id, slew_rate) << MCUX_IMX_SLEW_RATE_SHIFT) | \ (DT_PROP(node_id, input_enable) << MCUX_IMX_INPUT_ENABLE_SHIFT)) /* This struct must be present. It is used by the mcux gpio driver */ struct pinctrl_soc_pinmux { uint32_t mux_register; /* IOMUXC SW_PAD_MUX register */ uint32_t config_register; /* IOMUXC SW_PAD_CTL register */ uint32_t input_register; /* IOMUXC SELECT_INPUT DAISY register */ uint32_t gpr_register; /* IOMUXC GPR register */ uint8_t gpr_shift: 5; /* bitshift for GPR register write */ uint8_t mux_mode: 4; /* Mux value for SW_PAD_MUX register */ uint32_t input_daisy:4; /* Mux value for SELECT_INPUT_DAISY register */ uint8_t gpr_val: 1; /* value to write to GPR register */ }; struct pinctrl_soc_pin { struct pinctrl_soc_pinmux pinmux; uint32_t pin_ctrl_flags; /* value to write to IOMUXC_SW_PAD_CTL register */ }; typedef struct pinctrl_soc_pin pinctrl_soc_pin_t; /* This definition must be present. It is used by the mcux gpio driver */ #define MCUX_IMX_PINMUX(node_id) \ { \ .mux_register = DT_PROP_BY_IDX(node_id, pinmux, 0), \ .config_register = DT_PROP_BY_IDX(node_id, pinmux, 4), \ .input_register = DT_PROP_BY_IDX(node_id, pinmux, 2), \ .mux_mode = DT_PROP_BY_IDX(node_id, pinmux, 1), \ .input_daisy = DT_PROP_BY_IDX(node_id, pinmux, 3), \ IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 0), \ (.gpr_register = DT_PROP_BY_IDX(node_id, gpr, 0),)) \ IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 1), \ (.gpr_shift = DT_PROP_BY_IDX(node_id, gpr, 1),)) \ IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 2), \ (.gpr_val = DT_PROP_BY_IDX(node_id, gpr, 2),)) \ } #define Z_PINCTRL_PINMUX(group_id, pin_prop, idx) \ MCUX_IMX_PINMUX(DT_PHANDLE_BY_IDX(group_id, pin_prop, idx)) #define Z_PINCTRL_STATE_PIN_INIT(group_id, pin_prop, idx) \ { \ .pinmux = Z_PINCTRL_PINMUX(group_id, pin_prop, idx), \ .pin_ctrl_flags = Z_PINCTRL_MCUX_IMX_PINCFG_INIT(group_id), \ }, #define Z_PINCTRL_STATE_PINS_INIT(node_id, prop) \ {DT_FOREACH_CHILD_VARGS(DT_PHANDLE(node_id, prop), \ DT_FOREACH_PROP_ELEM, pinmux, Z_PINCTRL_STATE_PIN_INIT)}; \ #ifdef __cplusplus } #endif #endif /* ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_ */