# nRF9160 innblue V2.2 board configuration # Copyright (c) 2020 InnBlue # SPDX-License-Identifier: Apache-2.0 if BOARD_NRF9160_INNBLUE22 || BOARD_NRF9160_INNBLUE22_NS config BOARD default "nrf9160_innblue22" # For the secure version of the board the firmware is linked at the beginning # of the flash, or into the code-partition defined in DT if it is intended to # be loaded by MCUboot. If the secure firmware is to be combined with a non- # secure image (TRUSTED_EXECUTION_SECURE=y), the secure FW image shall always # be restricted to the size of its code partition. # For the non-secure version of the board, the firmware # must be linked into the code-partition (non-secure) defined in DT, regardless. # Apply this configuration below by setting the Kconfig symbols used by # the linker according to the information extracted from DT partitions. # Workaround for not being able to have commas in macro arguments DT_CHOSEN_Z_CODE_PARTITION := zephyr,code-partition if BOARD_NRF9160_INNBLUE22 && TRUSTED_EXECUTION_SECURE config FLASH_LOAD_SIZE default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) endif # BOARD_NRF9160_INNBLUE22 && TRUSTED_EXECUTION_SECURE if BOARD_NRF9160_INNBLUE22_NS config FLASH_LOAD_OFFSET default $(dt_chosen_reg_addr_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) config FLASH_LOAD_SIZE default $(dt_chosen_reg_size_hex,$(DT_CHOSEN_Z_CODE_PARTITION)) endif # BOARD_NRF9160_INNBLUE22_NS config BT_HCI_VS default y if BT config REGULATOR default y if SENSOR endif # BOARD_NRF9160_INNBLUE22 || BOARD_NRF9160_INNBLUE22_NS