Lines Matching full:3
149 #define FLASH_AREA_IMAGE_SCRATCH 3
248 3. Copies the (N+1)-th sector from the primary slot to the N-th sector of the
250 4. Repeats steps 2. and 3. until all the slots' sectors are swapped.
423 - Proceed to step 3.
431 - Proceed to step 3.
432 3. Proceed to image validation ...
445 0 1 2 3
446 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
449 ~ Swap status (BOOT_MAX_IMG_SECTORS * min-write-size * 3) ~
519 of 3 is explained below.
525 3. Swap size: When beginning a new swap operation, the total size that needs
531 - Swap type: Stored in bits 0-3. Indicating the type of swap operation in
545 | `BOOT_SWAP_TYPE_PERM` | 3 |
709 0-3. The set of tables in the previous section are not necessary in the resume
721 + Yes: Complete the partial swap operation; skip to step 3.
730 c. Proceed to step 3.
734 c. Proceed to step 3.
736 + No: Proceed to step 3.
738 3. Boot into image in primary slot.
816 + Loop 3. Iterate over all images
918 3. Persist completion of swap procedure to the primary slot image trailer.
941 The particulars of step 3 vary depending on whether an image is being tested,
982 0 1 2 3
983 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
1016 3. primary slot: image 1, secondary slot: image 0, scratch: N/A (s->0)
1035 state 3 | 0x01 | 0x02 | 0x03
1040 `BOOT_MAX_IMG_SECTORS * min-write-size * 3`. The only requirement for the index
1053 *sector, it uses at most min-write-size * 3 bytes for its own status area.*
1116 0-3 then resumes the operation. In other words, it applies the procedure defined