Lines Matching refs:command

130 When the wps_pin command is issued for an AP (including P2P GO) mode
163 changing them. The main difference with the wps_pin command is that
168 parameters are given to the wps_reg command:
236 example, the following command could be used to start the ER:
262   wps_reg command); this does not change the AP's configuration, but
323 "wps_nfc [BSSID]" command starts WPS protocol run with the local end as
327 "wps_nfc_token <WPS|NDEF>" command. The included nfc_pw_token tool
332 The "wps_nfc_config_token <WPS/NDEF>" command can be used to build an
334 interface (AP or P2P GO). The output value from this command is a
342 The "wps_nfc_config_token <WPS/NDEF> <network id>" command can be used
349 following wpa_cli command:
356 then be used with wps_reg command (when the NFC password token was from
362 "nfc_get_handover_req <NDEF> <WPS-CR>" command can be used to build the
368 "nfc_get_handover_sel <NDEF> <WPS> [UUID|BSSID]" command can be used to
385 The "wps_er_nfc_config_token <WPS/NDEF> <UUID|BSSID>" command can be
388 command is a hexdump of the selected AP configuration (WPS parameter