Lines Matching refs:group

66 wlan0). When using a separate virtual interface for group operations
67 (e.g., wlan1), the control interface for that group interface may need
122 having to maintain a group.
149 join-a-group style PD instead of GO Negotiation style PD.
156 Start P2P group formation with a discovered P2P peer. This includes
157 optional group owner negotiation, group interface setup, provisioning,
167 parameter can be used to request a persistent group to be formed. The
170 group where this device was the GO. The previously used parameters will
174 "join" indicates that this is a command to join an existing group as a
197 join-a-group operation rather than GO Negotiation.
234 	2 (group client only) or 4 (group owner only)
258     role -  Optional 2 (group client only) or 4 (group owner only)
267 Set up a P2P group owner manually (i.e., without group owner
270 a persistent group. Optional freq=<freq in MHz> can be used to force
282 p2p_group_remove <group interface>
284 Terminate a P2P group. If a new virtual network interface was used for
285 the group, it will also be removed. The network interface name of the
286 group interface is used as a parameter for this command.
290 Cancel an ongoing P2P group formation and joining-a-group related
292 had been authorized to start group formation), stops P2P find (if in
293 progress), stops pending operations for join-a-group, and removes the
294 P2P group interface (if one was used) that is in the WPS provisioning
295 step. If the WPS provisioning step has been completed, the group is not
302 can rejoin the group if it is in possession of a valid key. See p2p_set
560 p2p_invite [persistent=<network id>|group=<group ifname>] [peer=address]
564 Invite a peer to join a group (e.g., group=wlan1) or to reinvoke a
565 persistent group (e.g., persistent=4). If the peer device is the GO of
566 the persistent group, the peer parameter is not needed. Otherwise it is
570 cases). When reinvoking a persistent group, the GO device can specify
571 the frequency for the group with the freq parameter. When reinvoking a
572 persistent group, the P2P client device can use freq parameter to force
579 (These are used on the group interface.)
585 group. The second parameter is the address of the Enrollee or a string
594 client joins an existing group.
598 Get the passphrase for a group (only available when acting as a GO).
665 the group securely with p2p_remove_client command since that client's
668 disconnected, but it will be able to re-join the group since the PSK it
735 groups. If enabled, invitations to reinvoke a persistent group will be
764 (These are used on the group interface.)
785 p2p_group_add and p2p_invite to indicate which persistent group is to
805     conncap - always mask of 0x01 (new), 0x02 (group client), 0x04 (group owner)
824     conncap - always One of: 1 (new), 2 (group client), 4 (group owner) bits
835     persist - only if previous persistent group existed between peers and shall