Lines Matching refs:code
29 wpa_supplicant includes code in interact with both the P2P module
32 through these files, i.e., core P2P or WPS code does not interact
44 operations. Glue code is used to bind the P2P module API to the rest
184 the glue code outside the P2P module depends on the architecture used
201 \ref p2p_config::start_listen(). The glue code using the P2P module may
211 upper layer code with the \ref p2p_config::go_neg_req_tx() callback.
222 layer code is responsible for asking the user to provide the PIN to be
224 press for PBC mode. The glue code will need to figure out the intended
241 lower layer code to transmit an Action frame during group owner
250 upper layer management code or the glue code using the P2P module API
254 results. The upper layer code is also responsible for timing out WPS
260 started. The upper layer management code is responsible for configuring
268 attempts to be started. The upper layer management code is responsible
325 code outside the P2P module depends on the architecture used in the
341 The SME/MLME code that managements IEEE 802.11 association processing
350 The SME/MLME code that takes care of replying to Probe Request frames