Lines Matching refs:interface

2 \page ctrl_iface_page wpa_supplicant control interface
4 wpa_supplicant implements a control interface that can be used by
9 interface. External programs can link this file into them and then use
16 for the control interface and Windows version UDP sockets. The use of
21 \section using_ctrl_iface Using the control interface
26 interface with \ref wpa_ctrl_open() and to send commands with
29 wpa_supplicant uses the control interface for two types of communication:
34 interface connection without specific request from the external program
36 attach to the control interface with \ref wpa_ctrl_attach() to receive these
39 If the control interface connection is used both for commands and
44 control interface connections by calling \ref wpa_ctrl_open() twice and
51 Once the control interface connection is not needed anymore, it should
57 \section ctrl_iface_cmds Control interface commands
64 to the control interface commands. The expected reply is \c PONG if the
413 group owner negotiation, group interface setup, provisioning, and
420 optional group owner negotiation, group interface setup, provisioning,
456 Terminate a P2P group. If a new virtual network interface was used for
457 the group, it will also be removed. The network interface name of the
458 group interface is used as a parameter for this command.
663 \section ctrl_iface_events Control interface events
668 interface with \ref wpa_ctrl_attach().
670 The event messages will be delivered over the attach control interface
689 delivered over the attached control interface. LEVEL command can be
941 started. Additional parameters: network interface name for the group,
954 Additional parameters: network interface name for the group, role