Lines Matching refs:command

41 unsolicited message between the command request and response.
46 unsolicited messages. This way command request/response pairs will
63 This command can be used to test whether wpa_supplicant is replying
185 Example command:
247 \c LIST_NETWORKS command output.
264 Disconnect and wait for \c REASSOCIATE or \c RECONNECT command before
289 Get detailed per-BSS scan results. \c BSS command can be used to
296 There are two options for selecting the BSS with the \c BSS command:
324 \c LIST_NETWORKS command output.
330 \c LIST_NETWORKS command output. Special network id \c all can be
337 \c LIST_NETWORKS command output. Special network id \c all can be
343 Add a new network. This command creates a new network with empty
345 configured it can be enabled with \c ENABLE_NETWORK command. \c ADD_NETWORK
352 \c LIST_NETWORKS command output. Special network id \c all can be
359 \c LIST_NETWORKS command output.
361 This command uses the same variables and data formats as the
375 \c LIST_NETWORKS command output.
426 the command return code), PIN# means that a pre-selected PIN can be
433 "join" indicates that this is a command to join an existing group as a
448 duration for the Listen operation in seconds. This command may not
458 group interface is used as a parameter for this command.
472 parameters for this command are the P2P device address of the peer and
487 command are the device address of the peer device (or 00:00:00:00:00:00
495 This command returns an identifier for the pending query (e.g.,
503 Cancel a pending P2P service discovery request. This command takes a
511 Reply to a service discovery query. This command takes following
549 Fetch information about a discovered peer. This command takes in an
559 command disables extended listen timing. When enabling the feature,
570 \c CTRL-RSP- (\a WPA_CTRL_RSP macro) prefix in a command with matching
689 delivered over the attached control interface. LEVEL command can be
966 random PIN generated for this connection. P2P_CONNECT command can be
992 peer_address. P2P_CONNECT command can be used to accept the request.
1004 after the event prefix: peer_address. P2P_CONNECT command can be used to